Gravity Effects on Fluid Front Dynamics during Mold Filling

Abstract

The effect of gravity on free surface shape during the filling of a disk-shaped cavity is experimentally studied. A disk-shaped mold cavity is constructed to measure spreading of the fluid front due to gravity. Fluid front sensors are mounted on the top and bottom mold walls at three radial locations. The time the fluid front reaches these sensor locations is recorded. This data is used to calculate the radial distance between the top and bottom of the fluid front at each sensor location. The important parameters that govern the fluid front dynamics are identified as the Reynolds, Bond, and Capillary numbers. Spreading is found to be mainly dependent on the Bond number, such that a large change in spreading is observed due to a small change in Bond number. Spreading increases with decreasing Capillary number and remains nearly constant over the range of Reynolds numbers studied.

Get full access to this article

View all access options for this article.

References

1. Behrens, R.A. , Crochet, M.J. , Denson, C.D. and Metzner, A.B. , “Transient Free-Surface Flows: Motion of a Fluid Advancing in a Tube,” AIChE Journal,33(7), pp. 1178-1186, 1987.

2. Jansons, K.M. , “Moving Contact Lines at Non-Zero Capillary Number,” J. Fluid Mech.,167, pp. 393-407, 1986.

3. Dussan, E.B. and Davis, S.H. , “On the Motion of a Fluid-Fluid Interface along a Solid Surface,” J. Fluid Mech.,65(1), pp. 71-95, 1974.

4. Rame, E. and Garoff, S. , “Micropscopic and Macroscopic Dynamic Interface Shapes and the Interpretation of Dynamic Contact Angles,” J. Colloid and Interface Sci.,177, 234-244, 1996.

5. Gennes, P.G. , Hua, X. and Levinson, P. , “Dynamics of Wetting: Local Contact Angles,” J. Fluid Mech., 212, pp. 55-63, 1989.

6. Ström, G. , Fredriksson, M. , Steinus, P. and Radoev, B. , “Kinetics of Steady State Wetting,” J. Colloid and Interface Sci.,134, 107-116, 1989.

7. Blake, J.W., “Studies in Reaction Injection Mold Filling,” Ph.D. Thesis, University of Minnesota, 1987.

8. Blake, J.W. and Macosko, C.W. , “The Kinematics of Fountain Flow in Mold-Filling,” AIChE Journal,33(7), pp. 1168-1177, 1987.

9. Chen, Q. , Rame, E. and Garoff, S. , “The Breakdown of Asymptotic Hydrodynamic Models of Liquid Spreading at Increasing Capillary Number,” Phys. Fluids,7(11), 2631-2639, 1995.

10.

10. Hocking, L.M. , “Rival Contact-Angle Models and the Spreading of Drops,” J. Fluid Mech.,239, pp. 671-681, 1991.

11.

11. Brosius, D. and Wadsworth, M. , “Resin Transfer Molding of a Complex Composite Aircraft Structure,” in Composites in Manufacturing,Ed. Strong, A.B. , pp. 111-128, Society of Manufacturing Engineers, 1991.

12.

12. Hwa, M.J., “Interfacial Properties of Modified Glass Fibers in Thermoset and Model Resins,” Masters Thesis, University of Oklahoma, 1998.