Fatigue Issues of Polymeric Foam Sandwich Core Materials in Simple Shear

Abstract

Obtaining the fatigue properties of sandwich core materials is a particularly difficult issue. This work evaluates the ASTM C 394 test procedure for determining the fatigue properties of core materials using compression-compression loading. The stress concentration at the ends of the specimen where the specimen meets the fixture has been suggested to lead to premature failures. A geometric optimization of specimen ends was attempted to minimize the effects of the stress concentration. This resulted in removing a circular arc of material from the specimen ends. While this allowed the stress concentration to be shifted away from the corner interface of the specimen and fixture, it did not seem to positively influence the fatigue life for the load levels tested. Fatigue results obtained using the compression-compression loading compared well with data obtained using other test methods, including four-point bending. This suggested that the current ASTM C 394 test standard, when used with compression-compression loading, allows acceptable fatigue data to be obtained for foam core materials.

Get full access to this article

View all access options for this article.

References

1. “C 393-94 : Standard Method of Flexure Test of Flat Sandwich Constructions,” Annual Book of ASTM Standards, Vol. 15.03, 1998, pp. 21-24.

2. “C 273 -94 : Standard Test Method for Shear Properties of Sandwich Core Materials,” Annual Book of ASTM Standards, Vol. 15.03, 1998, pp. 5-7.

3. “C 394 -94 : Standard Test Method for Shear Fatigue of Sandwich Core Materials,” Annual Book of ASTM Standards, Vol. 15.03, 1998, pp. 25-26.

4. Olsson, K-A. and A. Lonno . 1992. “Sandwich Constructions—Recent Research and Development: GRP-Sandwich Technology for High-Speed Marine Vessels,” Sandwich Constructions 2: Proceedings of the Second International Conference on Sandwich Constructions, 9-12 March 1992, Gainesville, FL, USA, pp. 807-823.

5. Burman, M. and D. Zenkert . 1997. “Fatigue of Foam Core Sandwich Beams -1: Undamaged Specimens,” International Journal of Fatigue, Vol. 19, No 7, pp. 1549-1554.

6. Olsson, K-A. and A. Lonno . 1989. “Test Procedures for Foam Core Materials,” Sandwich Constructions 1: Proceedings of the First International Conference on Sandwich Constructions,19-21 June 1989, Stockholm, Sweden, pp. 293-318.

7. DeSautel, J. M. 1997. “Defining Core Properties for Composite Sandwich Panels,” M.S. Thesis, Michigan Technological University.

8. Shenoi, R. A. , S. D. Clark and H. G. Allen . 1995. “Fatigue Behavior of Polymer Composite Sandwich Beams,” Journal of Composite Materials, Vol. 29, No. 18, pp. 2423-2445.

9. Aamlid, O. , A. T. Echtermeyer , D. McGeorge and L. Buene . 1993. “Behavior of Cellular Foam Core Materials in GRP Sandwich Under Fatigue,” Advanced Composites’93: Proceedings of the International Conference on Advanced Composite Materials, 15-19 February, 1993, Australia, pp. 533-539.