Abstract
Abstract
We propose a pneumatic bending actuator integrated with a low-melting-point alloy-based variable stiffness endoskeleton that can bend at multiple points and maintain its bent shape without power supply. Local stiffness of the soft actuator can be altered by melting or hardening the endoskeleton with electric heat applied through embedded metal wires. Bending points of the actuator can be changed by selecting different points of the endoskeleton to be melted, and the bending angle can be controlled by injected air pressure. The shape of the bent actuator is maintained by hardening the alloy even when pressure is reduced to the initial state. We demonstrate that the actuator can be bent differently with only one pneumatic actuation layer by combining multipoint bending and the shape retention function, and thus the actuator can be used for lifting, holding, and unloading an object. We believe that the simple machinery of the actuator will be useful in programming complicated motions of soft robotic fingers, fins, and tentacles.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
