Abstract
To improve the recovery rate of oil in the formation, oil recovery technology has been continuously studied. Considering the experimental cost and data measurement in oil recovery research, laboratory oil recovery is the most effective method. The rock core model used in the simulation directly affects whether the research results are credible. However, the current three-dimensional rock core model manufacturing methods and corresponding models lack of reproducible, customizable, and visualized characteristics. In this study, a reproducible rock core model of microsphere accumulation based on the structure of natural rock core was designed and manufactured by microstereolithography. Oil recovery experiments and simulation studies show that the rock core model has similar flow characteristics to natural rock cores. In addition, resin rock core models with different structures and hydrogel rock core models with deformability are also manufactured by microstereolithography and used for simulation analysis. This research provides an effective and reproducible rock core structure model for the experiment of oil recovery research.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
