Abstract
In this study, the effect of the post-curing process as well as the long-term weathering behavior were studied for three different three-dimensional printable, pigmented (black), nonstabilized, ultraviolet (UV) cure resin formulations (A and B being thiol–ene chemistry, and C being acrylate chemistry). To study the effect of the post-cure process, the printed parts were post-cured using one of five different processes: no post-cure, UV-only, heat-only, UV+heat, and electron beam (EB) post-curing. Bulk tensile properties and nanohardness were measured for each of the systems and post-cure conditions. For weathering studies, the parts were post-cured using the recommended UV-only process and exposed using the ASTM D7869 exterior weathering protocol. The results show that the post-cure process had a significant effect on the final mechanical properties of the resins and was dependent on the underlying resin chemistry. Thermal post-curing was not as effective as UV curing for Resin C compared with the two other resins, which could both undergo thermal polymerization. In addition, Resin B showed the smallest change in mechanical properties before and after post-curing, regardless of the type of post-curing process. EB post-curing, even at very low dosages, that is, from 0.05 to 1 Mrad, resulted in considerable post-cure cross-linking to the point of embrittlement and a significant drop in percent elongation at break for dosages above 0.5 Mrad. Although Resins A and C outperformed Resin B in photooxidation performance, all three resins demonstrated that promising results considering no hindered amine light stabilizers were used in the formulations.
Get full access to this article
View all access options for this article.