Abstract
The System of Rice Intensification (SRI) seeks to increase both the sustainability and the productivity of smallholder rice farms, but the adoption of this methodology is constrained by local access to appropriate mechanical equipment. Valuable information about real difficulties in the adoption of SRI was collected through communications with five field partners. Two primary mechanization obstacles were identified, that is, the availability and performance of a roller component on a push seeder and a rotor component on a push weeder. The potential of additive manufacturing (AM), and especially material extrusion three-dimensional (3D) printing (ME3DP), to assist in overcoming the identified obstacles was assessed for two cases while considering both local prototyping and low-volume production. A simplified cost model was used to compare with the cost of manufacturing both in the United States and locally in the field. The acquired data suggests that in specific cases current ME3DP technology can more rapidly provide functional parts, accelerating the design cycle and lowering cost by about a factor of 10 relative to local fabrication routes. In the case where mechanical performance is critical and dimensional precision and surface finish are not, wire arc metal AM appears promising, but it is not as economical as fabrication by traditional means in the field.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
