This study compares tribological performance of refined, bleached and deodorized (RBD) palm kernel (PK) as an alternative lubricant. An analysis was made for chemically modified RBD PK with zinc dialkyl dithiophosphate (ZDDP) additive to determine its tribological performance using modified pin-on-disc tribotester. Commercial mineral oil (SAE 40) was used as the benchmark in this study. The conditions for this experiment are sliding speed at 1.5 m/s, a normal load at 9.81 N, weight percentage of ZDDP for 0, 3 and 5%, lubricant quantity of 2.5 ml and test duration of 60 min. The findings revealed that RBD PK oil exhibits better anti-friction and anti-wear performance compared to commercial mineral oil (SAE 40). Besides, coefficient of friction is less dependent on ZDDP concentration, but anti-wear ability is dependent on the ZDDP additive concentration. ZDDP additive acts as a good anti-wear and antioxidant additive in RBD palm kernel.
DüzcükoğluH. and AcaroğluM.: ‘Lubrication properties of vegetable oils combined with boric acid and determination of their effects on wear’, Energy Sources Part A, 2009, 32, 275–285.
2.
ImranA., MasjukiH. H., KalamM. A., VarmanM., HasmelidinM., Al MahmudK.A.H., ShahirS.A., HabibullahM.: ‘Study of friction and wear characteristic of jatropha oil blended lube oil’, Procedia Eng., 2013, 68, 178–185.10.1016/j.proeng.2013.12.165
3.
IngT. C., Mohammed RafiqA. K., AzliY. and SyahrullailS.: ‘The effect of temperature on the tribological behavior of RBD palm stearin’, Tribol. Trans., 2012, 55, 539–548.10.1080/10402004.2012.680176
4.
JayadasN. H., Prabhakaran NairK. and AjithkumarG.: ‘Tribological evaluation of coconut oil as an environment-friendly lubricant’, Tribol. Int., 2007, 40, 350–354.10.1016/j.triboint.2005.09.021
5.
ShahabuddinM., MasjukiH. H., KalamM. A., BhuiyaM. M. K. and MehatH.: ‘Comparative tribological investigation of bio-lubricant formulated from a non-edible oil source (Jatropha oil)’, Ind. Crops Prod., 2013, 47, 323–330.10.1016/j.indcrop.2013.03.026
6.
AdhvaryuA., ErhanS. Z. and PerezJ. M.: ‘Tribological studies of thermally and chemically modified vegetable oils for use as environmentally friendly lubricants’, Wear, 2004, 257, 359–367.10.1016/j.wear.2004.01.005
7.
KabirM. A., HiggsC. F. and LovellM. R.: ‘A pin-on-disk experimental study on a green particulate-fluid lubricant’, J. Tribol., 2008, 130, 041801.10.1115/1.2908913
8.
ThottackkadM. V., PerikinalilR. K. and KumarapillaiP. N.: ‘Experimental evaluation on the tribological properties of coconut oil by the addition of CuO nanoparticles’, Int. J. Precis. Eng. Manuf., 2012, 13, 111–116.10.1007/s12541-012-0015-5
9.
WagnerH., LutherR. and MangT.: ‘Lubricant base fluids based on renewable raw materials’, Appl. Catal., A, 2001, 221, 429–442.10.1016/S0926-860X(01)00891-2
10.
HwangH. and ErhanS. Z.: ‘Modification of epoxidized soybean oil for lubricant formulations with improved oxidative stability and low pour point’, J. Am. Oil Chem. Soc., 2001, 78, 1179–1184.10.1007/s11745-001-0410-0
11.
ArumugamS. and SriramG.: ‘Effect of bio-lubricant and biodiesel-contaminated lubricant on tribological behavior of cylinder liner–piston ring combination’, Tribol. Trans., 2012, 55, 438–445.10.1080/10402004.2012.667517
12.
FoxN. J., TyrerB. and StachowiakG. W.: ‘Boundary lubrication performance of free fatty acids in sunflower oil’, Tribol. Lett., 2004, 16, 275–281.10.1023/B:TRIL.0000015203.08570.82
13.
ZhaoC., JiaoY., ChenY. K. and RenG.: ‘The tribological properties of zinc borate ultrafine powder as a lubricant additive in sunflower oil’, Tribol. Trans., 2014, 57, 425–434.10.1080/10402004.2013.878776
14.
NichollsM. A., DoT., NortonP. R., KasraiM. and BancroftG. M.: ‘Review of the lubrication of metallic surfaces by zinc dialkyl-dithiophosphates’, Tribiol. Int., 2005, 38, 15–39.10.1016/j.triboint.2004.05.009
15.
ItoK., MartinJ. M., MinfrayC. and KatoK.: ‘Formation mechanism of a low friction ZDDP tribofilm on iron oxide’, Tribol. Trans., 2007, 50, 211–216.10.1080/10402000701271010
16.
WanY. and XueQ.: ‘Effect of antiwear and extreme pressure additives on the wear of aluminium alloy in lubricated aluminium-on-steel contact’, Tribol. Int., 1995, 28, 553–557.10.1016/0301-679X(96)85543-5
17.
CastroW., WellerD. E., CheenkachornK. and PerezJ. M.: ‘The effect of chemical structure of basefluids on antiwear effectiveness of additives’, Tribol. Int., 2005, 38, 321–326.10.1016/j.triboint.2004.08.020
18.
TaylorL., DratvaA. and SpikesH. A.: ‘Friction and wear behavior of zinc dialkyldithiophosphate additive’, Tribol. Trans., 2000, 43, 469–479.10.1080/10402000008982366
19.
LinY. C. and SoH.: ‘Limitations on use of ZDDP as an antiwear additive in boundary lubrication’, Tribiol. Int., 2004, 37, 25–33.10.1016/S0301-679X(03)00111-7
20.
OssiaC. V., HanH. G. and KongH.: ‘Additive properties of saturated very long chain fatty acids in castor and jojoba oils’, J. Mech. Sci. Technol., 2008, 22, 1527–1536.10.1007/s12206-008-0506-6
21.
ShashidharaY. M. and JayaramS. R.: ‘Tribological studies on AISI 1040 with raw and modified versions of pongam and jatropha vegetable oils as lubricants’, Adv. Tribol., 2012, 2012, 1–6.10.1155/2012/560175
22.
MalequeM. A., MasjukiH. H. and HaseebA. S. M. A.: ‘Effect of mechanical factors on tribological properties of palm oil methyl ester blended lubricant’, Wear, 2000, 239, 117–125.10.1016/S0043-1648(00)00319-7
23.
ShahF. U., GlavatskihS. and AntzutkinO. N.: ‘Synthesis, physicochemical, and tribological characterization of S-Di-n-octoxyboron-O, O′-di-n-octyldithiophosphate’, ACS Appl. Mater. Interfaces, 2009, 1, 2835–2842.10.1021/am900572y
24.
ErhanS. Z. and AsadauskasS.: ‘Lubricant basestocks from vegetable oils’, Ind. Crops Prod., 2000, 11, 277–282.10.1016/S0926-6690(99)00061-8
25.
IngT. C., RafiqA. K. M., AzliY. and SyahrullailS.: ‘Tribological behaviour of refined bleached and deodorized palm olein in different loads using a four-ball tribotester’, Sci. Iran., 2012, 19, 1487–1492.
