Silicon carbide (SiC) fibres are widely used as promising reinforcement in ceramic matrix composites due to their excellent mechanical and thermal properties. In this work, sub-micrometer SiC fibres were prepared by electrospinning using polycarbosilane as the precursor, followed by curing in air and pyrolysing at high temperatures. The effect of the microstructure of SiC fibres on mechanical properties was investigated and the SiC fibre mats prepared at 1300°C for 2 h exhibited a mechanical strength of 184.5 ± 19.4 MPa. Hot-drawing was conducted on as-spun fibres during the curing process and the strength, Young's modulus, and flexibility of SiC fibre mats were improved. The strength with a drawing ratio of 200% reaches 243.0 ± 17.5 MPa. The enhancement of mechanical strength after hot-drawing is mainly attributed to the reduced defects in fibres, improvement in the orientation of the precursor fibres as well as the alignment of the molecular chains in the precursor fibres.
NaslainR.Design, preparation and properties of non-oxide CMCs for application in engines and nuclear reactors: an overview. Compos Sci Technol. 2004;64(2):155–170. doi:10.1016/S0266-3538(03)00230-6.
2.
KatohY, SneadLL, HenagerCH, Current status and recent research achievements in SiC/SiC composites. J Nucl Mater. 2014;455(1-3):387–397. doi:10.1016/j.jnucmat.2014.06.003.
3.
KatohY, SneadLL.Silicon carbide and its composites for nuclear applications - historical overview. J Nucl Mater. 2019.
4.
BunsellAR, PiantA.A review of the development of three generations of small diameter silicon carbide fibers. J Mater Sci. 2006;41(3):823–839. doi:10.1007/s10853-006-6566-z.
5.
YajimaS, HasegawaY, OkamuraK, Development of high tensile strength silicon carbide fiber using an organosilicon polymer precursor. Nature. 1978;273(5663):525–527. doi:10.1038/273525a0.
6.
HanT, LuoR, CuiG, Effect of fiber directionality on the microwave absorption properties of 3D braided SiCf/SiC composites. Ceram Int. 2019;45(6):7797–7803. doi:10.1016/j.ceramint.2019.01.085.
7.
GaoH, LuoF, WenQ, Effect of preparation conditions on mechanical, dielectric and microwave absorption properties of SiC fiber/mullite matrix composite. Ceram Int. 2019;45(9):11625–11632. doi:10.1016/j.ceramint.2019.03.034.
8.
LiuX, ZhangL, YinX, The microstructure and electromagnetic wave absorption properties of near-stoichiometric SiC fiber. Ceram Int. 2017;43(3):3267–3273. doi:10.1016/j.ceramint.2016.11.158.
9.
ZhangY, SongZ, YanY, Performance of Fe/SiC catalysts for cracking of toluene under microwave irradiation. Int J Hydrog Energy. 2018;43(15):7227–7236. doi:10.1016/j.ijhydene.2018.02.158.
10.
KimB, LiuY, HakY, Highly flexible, erosion resistant and nitrogen doped hollow SiC fibrous mats for high temperature thermal insulators. J Mater Chem A. 2017;5(6):2664–2672. doi:10.1039/C6TA09475A.
11.
LiQ, YinX, ZhangL, Effects of SiC fibers on microwave absorption and electromagnetic interference shielding properties of SiCf/SiCN composites. Ceram Int. 2016;42(16):19237–19244. doi:10.1016/j.ceramint.2016.09.089.
12.
WangPR, LiuFQ, WangH, A review of third generation SiC fibers and SiCf/SiC composites. J Mater Sci Technol. 2019;35(12):2743–2750. doi:10.1016/j.jmst.2019.07.020.
13.
LiM, ZhouX, YangH, Mechanical properties of the SiCf/SiC composites reinforced with KD-I and KD-II fibers fabricated assisted by a microwave heating method. Ceram Int. 2019;45(10):12957–12964. doi:10.1016/j.ceramint.2019.03.223
14.
SuiG, SunF, YangX, Highly aligned polyacrylonitrile-based nano-scale carbon fibers with homogeneous structure and desirable properties. Compos Sci Technol. 2013;87:77–85. doi:10.1016/j.compscitech.2013.08.001.
AndreasG, JoachimHW.Electrospinning: a fascinating method for the preparation of ultrathin fibers. Angew Chem Int Edit. 2007;46(30):5670–5703. doi:10.1002/anie.200604646.
17.
BajiA, MaiY, WongS, Electrospinning of polymer nanofibers: effects on oriented morphology, structures and tensile properties. Compos Sci Technol. 2010;70(5):703–718. doi:10.1016/j.compscitech.2010.01.010.
18.
CavaliereS, SubiantoS, SavychL, Electrospinning: designed architectures for energy conversion and storage devices. Energy Environ Sci. 2011;4(12):4761–4785. doi:10.1039/C1EE02201F.
19.
ZhouX, QiuY, YuJ, Tungsten carbide nanofibers prepared by electrospinning with high electrocatalytic activity for oxygen reduction. Int J Hydrog Energy. 2011;36(13):7398–7404. doi:10.1016/j.ijhydene.2011.03.081.
20.
SallesV, BernardS, BrioudeA, A new class of boron nitride fibers with tunable properties by combining an electrospinning process and the polymer-derived ceramics route. Nanoscale. 2010;2(2):215–217. doi:10.1039/B9NR00185A.
21.
HouH, GaoF, WeiG, Electrospinning 3C-SiC mesoporous fibers with high purities and well-controlled structures. Cryst Growth Des. 2012;12(1):536–539. doi:10.1021/cg201317b.
22.
TianQ, WuN, WangB, Fabrication of hollow SiC ultrafine fibers by single-nozzle electrospinning for high-temperature thermal insulation application. Mater Lett. 2019;239:109–112. doi:10.1016/j.matlet.2018.12.077.
23.
HouY, ChengL, ZhanY, Electrospinning of Fe/SiC hybrid fibers for highly efficient microwave absorption. ACS Appl Mater Interfaces. 2017;9(8):7265–7271. doi:10.1021/acsami.6b15721.
24.
YangX, DingY, ShenZ, High-strength electrospun carbon nanofibrous mats prepared via rapid stabilization as frameworks for Li-ion battery electrodes. J Mater Sci. 2019;54(17):11574–11584. doi:10.1007/s10853-019-03698-z.
25.
YangC, WuJ, DittaA, Effects of temperature and atmosphere on microstructural evolution and mechanical properties of KD-II SiC fibers. Ceram Int. 2020;46(15):24424–24434. doi:10.1016/j.ceramint.2020.06.225.
26.
GouY, WangH, JianK, Preparation and characterization of SiC fibers with diverse electrical resistivity through pyrolysis under reactive atmospheres. J Eur Ceram Soc. 2017;37(2):517–522. doi:10.1016/j.jeurceramsoc.2016.09.023.
27.
SanthoshB, IonescuE, AndreolliF, Effect of pyrolysis temperature on the microstructure and thermal conductivity of polymer-derived monolithic and porous SiC ceramics. J Eur Ceram Soc. 2020. doi:10.1016/j.jeurceramsoc.2020.09.028
28.
WangX, WangH, JianK.Synthesis and formation mechanism of α-Si3N4 single-crystalline nanowires via direct nitridation of H2-treated SiC fibers. Ceram Int. 2018;44(11):12847–12852. doi:10.1016/j.ceramint.2018.04.094.
29.
HanM, YinX, HouZ, Flexible and thermostable graphene/SiC nanowire foam composites with tunable electromagnetic wave absorption properties. ACS Appl Mater Interfaces. 2017;9(13):11803–11810. doi:10.1021/acsami.7b00951.
30.
WangP, ChengL, ZhangY, Flexible SiC/Si3N4 composite nanofibers with in situ embedded graphite for highly efficient electromagnetic wave absorption. ACS Appl Mater Interfaces. 2017;9(34):28844–28858. doi:10.1021/acsami.7b05382.
31.
HuangB, WangZ, HuH, Enhancement of the microwave absorption properties of PyC-SiCf/SiC composites by electrophoretic deposition of SiC nanowires on SiC fibers. Ceram Int. 2020;46(7):9303–9310. doi:10.1016/j.ceramint.2019.12.185.
32.
SugimotoM, ShimooT, OkamuraK, Reaction mechanisms of silicon carbide fiber synthesis by heat treatment of polycarbosilane fibers cured by radiation. I. evolved gas-analysis. J Am Ceram Soc. 1995;78(4):1013–1017. doi:10.1111/j.1151-2916.1995.tb08430.x.
33.
ShimooT, OkamuraK, TsukadaI, Thermal stability of low-oxygen SiC fibers fired under different conditions. J Mater Sci. 1999;34(22):5623–5631. doi:10.1023/A:1004797403391.
34.
CaoS, WangJ, WangH.High-temperature behavior and degradation mechanism of SiC fibers annealed in Ar and N2 atmospheres. J Mater Sci. 2016;51(9):4650–4659. doi:10.1007/s10853-016-9780-3.
35.
ShimeeT, TsukadaI, NarisawaM.Changes in properties of polycarbosilane-derived SiC fibers at high temperatures. J Ceram Soc Jap. 1997;105(7):559–563. doi:10.2109/jcersj.105.559.
36.
YaoR, WangY, FengZ.The effect of high-temperature annealing on tensile strength and its mechanism of Hi-Nicalon SiC fibers under inert atmosphere. Fatigue Fract Eng Mater Struct. 2008;31(9):777–787. doi:10.1111/j.1460-2695.2008.01264.x.
37.
MichaelS.DEffect of composition and heat treatment conditions on the tensile strength and creep resistance of SiC-based fibers. J Eur Ceram Soc. 1999;19(13-14):2305–2315. doi:10.1016/S0955-2219(99)00114-4.
38.
TresslerR, Bodetn JiarE.Microstructural instability and the resultant strength of Si-C-O (Nicalon) and Si-N-C-O (HPZ) fibres. J Eur Ceram Soc. 1996;16(6):653–664. doi:10.1016/0955-2219(95)00178-6.
39.
ChawlaS, CaiJ, NaraghiM.Mechanical tests on individual carbon nanofibers reveals the strong effect of graphitic alignment achieved via precursor hot-drawing. Carbon. 2017;117:208–219. doi:10.1016/j.carbon.2017.02.095.
40.
LianF, LiuJ, MaZ, Stretching-induced deformation of polyacrylonitrile chains both in quasicrystals and in amorphous regions during the in situ thermal modification of fibers prior to oxidative stabilization. Carbon. 2012;50(2):488–499. doi:10.1016/j.carbon.2011.09.003.
41.
ZhouZ, LiuK, LaiC, Graphitic carbon nanofibers developed from bundles of aligned electrospun polyacrylonitrile nanofibers containing phosphoric acid. Polymer. 2010;51(11):2360–2367. doi:10.1016/j.polymer.2010.03.044.
42.
HouY, ChengL, ZhangY, Enhanced flexibility and microwave absorption properties of HfC/SiC nanofiber mats. ACS Appl Mater Interfaces. 2018;10(35):29876–29883. doi:10.1021/acsami.8b07980.
