Electrochemical techniques such as Polarisation and Galvanic tests as well as immersion test were used to analyse both the effects of different Bi contents and the length scale of dendritic spacings on Zn–8 wt-%Al–(1.5, 2.3 and 3 wt-%Bi) alloys on their corrosion behaviour. The results revealed that no significant differences in the corrosion kinetics were observed with the scale of the dendritic and lamellar spacings. Conversely, the corrosion behaviour was shown to be dependent on the alloy Bi content. Despite the cathodic character of Bi, its addition to the Zn–8%Al alloy was shown to reduce the corrosion rate as compared with that of the binary alloy.
HeYLiDWangD. Corrosion resistance of Zn-Al co-cementation coatings on carbon steels. Mater Lett. 2002; 56: 554–559. doi: 10.1016/S0167-577X(02)00551-7.
2.
Salgueiro AzevedoMAllélyCOgleK. Corrosion mechanisms of Zn(Mg,Al) coated steel: 2. The effect of Mg and Al alloying on the formation and properties of corrosion products in different electrolytes. Corros Sci.2015; 90: 482–490. doi: 10.1016/j.corsci.2014.07.042.
3.
BabinecMKusýMGondekJ.The corrosion performance of Zn-Al-Mg based alloys with tin addition in neutral salt spray environment. J Achiev Mater Manuf Eng. 2015; 70: 70–77.
4.
ProsekTLarchéNVlotM. Corrosion performance of Zn-Al-Mg coatings in open and confined zones in conditions simulating automotive applications. Mater Corros. 2010; 61: 412–420. doi: 10.1002/maco.200905425.
5.
ParkJHHagioTKamimotoY. Enhancement of corrosion resistance by lamination of Mg film on Zn-55Al-1.6Si-coated steel by physical vapor deposition. Surf Coatings Technol. 2020; 387: 125537. doi: 10.1016/j.surfcoat.2020.125537.
6.
SongJZhangJWangJ. Effect of mixed bacteria on corrosion properties of Zn-Al-Cd sacrificial anode. Int J Electrochem Sci. 2019; 14: 1610–1619. doi: 10.20964/2019.02.30.
7.
ZhangJMaXYuZ. Corrosion performance of Zn-Al-Cd alloy in Amphora-containing f/2 culture medium. Int J Electrochem Sci. 2016; 11: 2018–2028.
8.
WangKWangSXiongT. Properties of Zn-Al-Mg-TiO2 coating prepared by cold spraying. Surf Coatings Technol. 2020; 387: 125549. doi: 10.1016/j.surfcoat.2020.125549.
9.
ChenTCChouCCYungTY. Wear behavior of thermally sprayed Zn/15Al, Al and Inconel 625 coatings on carbon steel. Surf Coatings Technol.2016; 303: 78–85. doi: 10.1016/j.surfcoat.2016.03.095.
XiaoYLiMWangL. Interfacial reaction behavior and mechanical properties of ultrasonically brazed Cu/Zn-Al/Cu joints. Mater Des. 2015; 73: 42–49. doi: 10.1016/j.matdes.2015.02.016.
13.
BerentKPstruśJGancarzT.Thermal and microstructure characterization of Zn-Al-Si alloys and chemical reaction with Cu substrate during spreading. J Mater Eng Perform. 2016; 25: 3375–3383. doi: 10.1007/s11665-016-2074-8.
14.
GancarzTCempuraG.Characterization of ZnAl cast alloys with Li addition. Mater Des. 2016; 104: 51–59. doi: 10.1016/j.matdes.2016.05.019.
15.
GancarzTBerentKSkuzaW. Soldering of Mg joints using Zn-Al solders. Metall Mater Trans A Phys Metall Mater Sci. 2018; 49: 2684–2691. doi: 10.1007/s11661-018-4617-0.
16.
ÜnlüBS.Investigation of tribological and mechanical properties of metal bearings. Bull Mater Sci. 2009; 32: 451–457.
17.
ŞevikH.The effect of silver on wear behaviour of zinc-aluminium-based ZA-12 alloy produced by gravity casting. Mater Charact. 2014; 89: 81–87. doi: 10.1016/j.matchar.2013.12.015.
18.
BabićMNinkovićR.Zn-Al alloys as tribomaterials. Tribol Ind. 2004; 26: 3–7.
SavaşkanTMalekiRA.Friction and wear properties of Zn-25Al-based bearing alloys. Tribol Trans. 2014; 57: 435–444. doi: 10.1080/10402004.2014.880540.
21.
PolaAMontesanoLGelfiM. Comparison of the sliding wear of a novel Zn alloy with that of two commercial Zn alloys against bearing steel and leaded brass. Wear. 2016; 368-369: 445–452. doi: 10.1016/j.wear.2016.10.017.
22.
TürkAKurnazCŞevikH.Comparison of the wear properties of modified ZA-8 alloys and conventional bearing bronze. Mater Des. 2007; 28: 1889–1897. doi: 10.1016/j.matdes.2006.04.010.
23.
Abou El-KhairMTDaoudAIsmailA.Effect of different Al contents on the microstructure, tensile and wear properties of Zn-based alloy. Mater Lett. 2004; 58: 1754–1760. doi: 10.1016/j.matlet.2003.10.058.
24.
SeptimioRSCostaTASilvaCAP. Correlation between unsteady-state solidification thermal parameters and microstructural growth of Zn–8 mass% Al and Zn–8 mass% Al–XBi tribological alloys. J Therm Anal Calorim. 2020; 139: 1741–1761. doi: 10.1007/s10973-019-08600-2.
25.
WangLShinoharaTZhangBP.Corrosion behavior of Mg, AZ31, and AZ91 alloys in dilute NaCl solutions. J Solid State Electrochem. 2010; 14: 1897–1907. doi: 10.1007/s10008-010-1020-1.
26.
AkiyamaEZhangZWatanabeY. Effects of severe plastic deformation on the corrosion behavior of aluminum alloys. J Solid State Electrochem. 2009; 13: 277–282. doi: 10.1007/s10008-007-0496-9.
da SilvaLJScheuerCJD'OliveiraASCM.Effect of microstructure on wear performance of NiCrSiBC coatings. Wear. 2019; 428-429: 387–394. doi: 10.1016/j.wear.2019.04.005.
29.
FreitasESSpinelliJECastelettiLC. Microstructure-wear behavior correlation on a directionally solidified Al-In monotectic alloy. Tribol Int. 2013; 66: 182–186. doi: 10.1016/j.triboint.2013.05.009.
30.
AcheCLopesMReisB. Dendritic spacing/columnar grain diameter of Al–2Mg–Zn alloys affecting hardness, tensile properties, and dry sliding wear in the as-cast/heat-treated conditions. Adv Eng Mater. 2020; 22: 1–11. doi: 10.1002/adem.201901145.
31.
ChenWZengWXuJ. Deformation behavior and microstructure evolution during hot working of Ti60 alloy with lamellar starting microstructure. J Alloys Compd. 2019; 792: 389–398. doi: 10.1016/j.jallcom.2019.03.345.
32.
LiPFanJHanY. Microstructure evolution and properties of tungsten reinforced by additions of ZrC. Rare Met Mater Eng. 2018; 47: 1695–1699. doi: 10.1016/s1875-5372(18)30152-8.
33.
KakitaniRReyesRVGarciaA. Effects of melt superheating on the microstructure and tensile properties of a ternary Al-15 Wt Pct Si-1.5 Wt Pct Mg alloy. Metall Mater Trans A Phys Metall Mater Sci. 2019; 50: 1308–1322. doi: 10.1007/s11661-018-5058-5.
34.
SharmaLChhibberR.Microstructure evolution and electrochemical corrosion behaviour of API X70 linepipe steel in different environments. Int J Press Vessel Pip. 2019; 171: 51–59. doi: 10.1016/j.ijpvp.2019.01.013.
35.
GrimmMLohmüllerASingerRF. Influence of the microstructure on the corrosion behaviour of cast Mg-Al alloys. Corros Sci. 2019; 155: 195–208. doi: 10.1016/j.corsci.2019.04.024.
ReisBPLopesMMGarciaA. The correlation of microstructure features, dry sliding wear behavior, hardness and tensile properties of Al-2 wt%Mg-Zn alloys. J Alloys Compd. 2018; 764: 267–278. doi: 10.1016/j.jallcom.2018.06.075.
38.
CostaTADiasMFreitasES. The effect of microstructure length scale on dry sliding wear behaviour of monotectic Al-Bi-Sn alloys. J Alloys Compd. 2016; 689: 767–776. doi: 10.1016/j.jallcom.2016.08.051.
39.
DevillersLPNiessenP.The mechanism of intergranular corrosion of dilute zinc-aluminium alloys in hot water. Corros Sci. 1976; 16: 243–250. doi: 10.1016/0010-938X(76)90050-0.
40.
BobićBMitrovicSBabicM. Corrosion of aluminium and zinc-aluminium alloys based metal-matrix composites. Tribol Ind. 2009; 31: 44–53.
41.
YangLZhangYZengX. Corrosion behaviour of superplastic Zn-Al alloys in simulated acid rain. Corros Sci. 2012; 59: 229–237. doi: 10.1016/j.corsci.2012.03.013.
42.
GancarzTMechKGuśpielJ. Corrosion studies of Li, Na and Si doped Zn-Al alloy immersed in NaCl solutions. J Alloys Compd. 2018; 767: 1225–1237. doi: 10.1016/j.jallcom.2018.07.109.
43.
AhmedMM.Corrosion behaviour of Zn-Al-Cu alloy in HCl solution and its inhibition. Port Electrochim Acta. 2006; 24: 1–22.
44.
DiasMOliveiraRKakitaniR. Effects of solidification thermal parameters and Bi doping on silicon size, morphology and mechanical properties of Al-15 wt.% Si-3.2 wt.% Bi and Al-18 wt.% Si-3.2 wt.% Bi alloys. J Mater Res Technol. 2020; 9: 3460–3470. doi: 10.1016/j.jmrt.2020.01.083.
45.
KakitaniRCruzCBLimaTS. Transient directional solidification of a eutectic Al–Si–Ni alloy: macrostructure, microstructure, dendritic growth and hardness. Materialia. 2019; 7: 100358. doi: 10.1016/j.mtla.2019.100358.
46.
KakitaniRReyesRVGarciaA. Relationship between spacing of eutectic colonies and tensile properties of transient directionally solidified Al-Ni eutectic alloy. J Alloys Compd. 2018; 733: 59–68. doi: 10.1016/j.jallcom.2017.10.288.
47.
VerissimoNCBritoCAfonsoCR. Microstructure characterization of a directionally solidified Mg-12 wt.%Zn alloy: equiaxed dendrites, eutectic mixture and type/ morphology of intermetallics. Mater Chem Phys. 2018; 204: 105–131. doi: 10.1016/j.matchemphys.2017.10.032.
48.
XavierMGCCruzCBKakitaniR. Directional solidification of a Sn-0.2Ni solder alloy in water-cooled copper and steel molds: related effects on the matrix micromorphology, nature of intermetallics and tensile properties. J Alloys Compd. 2017; 723: 1039–1052. doi: 10.1016/j.jallcom.2017.06.329.
49.
GündüzMÇadirliE.Directional solidification of aluminium-copper alloys. Mater Sci Eng A. 2002; 327: 167–185. doi: 10.1016/S0921-5093(01)01649-5.
PourbaixM.Atlas of electrochemical equilibria in aqueous solutions. Houston, TX: National Association of Corrosion; 1974.
52.
HuertaEO.Corrosión y degradación de materiales.2a ed. Madrid: Editorial Síntesis; 2012.
53.
SeptimioRSArenasMACondeA. Correlation between microstructure and corrosion behaviour of Bi-Zn solder alloys. Corros Eng Sci Technol. 2019; 54: 362–368. doi: 10.1080/1478422X.2019.1600836.
