Abstract
A growing trend in the use of reciprocal walking orthoses for infant paraplegic patients, and their application for control of the lower limbs in very young total body involved cerebral palsy patients, has created a need for smaller components.
A prototype design of a hip joint has been produced which provides the following features: adjustable range of flexion/extension control; override on stops to permit sitting; high lateral rigidity; no lateral bearing play; very high rigidity in the sagittal plane; low friction bearings; high resistance to torque about the vertical axis. In addition a size envelope which is more in keeping with the dimensions of infant patients was an important objective.
Comparisons were made of the computed structural properties of the prototype joint and existing routinely available standard orthotic hip joints. In each plane of loading the prototype joint had the highest identified structural property. The hinge-bearing material was tested in a representative joint with 200,000 cycles of typical loading. It was also field tested on adult orthoses over a minimum of a 12-month period with the most vigorous of walkers. In neither test did excessive play develop. The mechanical properties of the joint were established using tests advocated in the British Standard on testing lower limb orthosis knee joints. These showed the joint had structurally equivalent performance to a successful reciprocal walking orthosis hip joint, and that the mode of failure was essentially ductile in nature.
Production development of the joint is now being undertaken.