The effect of Zr addition on the microstructure and impact toughness in the coarse-grained heat-affected zone (CGHAZ) of high-strength low-alloy steels subjected to 100 kJ cm-1 heat input was investigated. The second- phase particles were mainly Al–Ti complex oxides and (Ti,Nb)N precipitates in Zr-free steel, whereas lots of finer Zr–Al–Ti complex oxides and (Al,Ti,Nb)N precipitates were formed in Zr-bearing steel because of Zr addition. These finer oxides and precipitates effectively restricted the austenite grain growth by pinning effect during welding thermal cycle, and smaller and more uniform prior austenite grains were obtained in CGHAZ of Zr-bearing steel. Furthermore, more acicular ferrite grains nucleated on Zr–Al–Ti complex oxides, inducing formation of fine-grained microstructure in CGHAZ of Zr-bearing steel. The toughness improvement in CGHAZ of Zr-bearing steel with dimple fracture surface was attributed to the grain refinement by pinning effect and acicular ferrite formation.
Get full access to this article
View all access options for this article.
References
1.
BhadeshiaHKDH.Bainite in steels. London: IOM Communications Ltd;2001:285.
2.
KojimaAYoshiiKHadaTet al.Development of high HAZ toughness steel plates for box columns with high heat input welding. Nippon Steel Tech Rep.2004;90:39–44.
3.
OgibayashiS.Advances in technology of oxide metallurgy. Nippon Steel Tech Rep. 1994;61:70–76.
4.
ZhengWWuZHLiGQet al.Effect of Al content on the characteristics of inclusions in Al-Ti complex deoxidized steel with calcium treatment. ISIJ Int. 2014;54(8):1755–1764. doi: 10.2355/isijinternational.54.1755
5.
LeeJLPanYT.Microstructure and toughness of the simulated heat-affected zone in Ti-and Al-killed steels. Mater Sci Eng A. 1991;136:109–119. doi: 10.1016/0921-5093(91)90446-T
6.
KojimaAKiyoseAUemoriRet al.Super high HAZ toughness technology with fine microstructure imparted by fine particles. Nippon Steel Tech Rep. 2004;90:292–295.
7.
SakataKSuitoH.Grain-growth-inhibiting effects of primary inclusion particles of ZrO2 and MgO in Fe-10 mass pct Ni alloy. Metall Mater Trans A. 2000;31(4):1213–1223. doi: 10.1007/s11661-000-0117-z
8.
ChaiFYangCFSuHet al.Effect of Zr addition to Ti-killed steel on inclusion formation and microstructural evolution in welding induced coarse-grained heat affected zone. Acta Metall Sin. 2008;21(3):220–226. doi: 10.1016/S1006-7191(08)60042-3
9.
GuoAMLiSRGuoJet al.Effect of zirconium addition on the impact toughness of the heat affected zone in a high strength low alloy pipeline steel. Mater Character. 2008;59(2):134–139. doi: 10.1016/j.matchar.2006.11.028
10.
ZhangLYuanZXSongSHet al.Austenite grain growth in heat affected zone of Zr-Ti bearing microalloyed steel. J Iron Steel Res Int. 2012;19(2):73–78. doi: 10.1016/S1006-706X(12)60063-6
11.
WangCMisraRDKShiMHet al.Transformation behavior of a Ti-Zr deoxidized steel: microstructure and toughness of simulated coarse grain heat affected zone. Mater Sci Eng A.2014;594:218–228. doi: 10.1016/j.msea.2013.11.028
12.
ShiMZhangPZhuF.Toughness and microstructure of coarse grain heat affected zone with high heat input welding in Zr-bearing low carbon steel. ISIJ Int. 2014;54(1):188–192. doi: 10.2355/isijinternational.54.188
ZhouBLiGWanXet al.In-situ observation of grain refinement in the simulated heat-affected zone of high-strength low-alloy steel by Zr-Ti combined deoxidation. Met Mater Int. 2016;22(2):267–275. doi: 10.1007/s12540-016-5301-9
15.
WanXLWuKMHuangGet al.Toughness improvement by Cu addition in the simulated coarse-grained heat-affected zone of high-strength low-alloy steels. Sci Technol Welding Joining. 2016;21(4):295–302. doi: 10.1080/13621718.2015.1104098
16.
HuangGWanXLWuKM.Effect of Cr content on microstructure and impact toughness in the simulated coarse-grained heat-affected zone of high-strength low-alloy steels. Steel Res Int. 2016;87(11):1426–1434. doi: 10.1002/srin.201500424
17.
WangHRWangWGaoJQ.Precipitates in two Zr-bearing HSLA steel plates. Mater Lett. 2010;64(2):219–222. doi: 10.1016/j.matlet.2009.10.053
18.
HinoMItoK.Thermodynamic data for steelmaking. Sendai: Tohoku University Press;2010.
19.
WanXWuKHuangGet al.In situ observation of austenite grain growth behavior in the simulated coarse-grained heat-affected zone of Ti-microalloyed steels. Int J Miner Metal Mater. 2014;21(9):878–885. doi: 10.1007/s12613-014-0984-8
20.
MabuchiHUemoriRFujiokaM.The role of Mn depletion in intra-granular ferrite transformation in the heat affected zone of welded joints with large heat input in structural steels. ISIJ Int. 1996;36(11):1406–1412. doi: 10.2355/isijinternational.36.1406
RicksRAHowellPRBarritteGS.The nature of acicular ferrite in HSLA steel weld metals. J Mater Sci. 1982;17(13):732–740. doi: 10.1007/BF00540369
23.
ShimJHByunJSChoYWet al.Mn absorption characteristics of Ti2O3 inclusions in low carbon steels. Scr Mater. 2001;44(1):49–54. doi: 10.1016/S1359-6462(00)00560-1
24.
ShigesatoGSugiyamaM.Development of in situ observation technique using scanning ion microscopy and demonstration of Mn depletion effect on intra-granular ferrite transformation in low-alloy steel. J Electron Microsc. 2002;51(6):359–367. doi: 10.1093/jmicro/51.6.359
25.
WanXLWangHHChengLet al.The formation mechanisms of interlocked microstructures in low-carbon high-strength steel weld metals. Mater Charact. 2012;67:41–51. doi: 10.1016/j.matchar.2012.02.007
26.
LiYWanXLChengLet al.First-principles calculation of the interaction of Mn with ZrO2 and its effect on the formation of ferrite in high-strength low-alloy steels. Scr Mater.2014 ;75:78–81. doi: 10.1016/j.scriptamat.2013.11.028
