In this work, long-chain hexadecyl siloxane groups were introduced into hydroxylated multi-walled carbon nanotubes (MWCNTs-OH) to obtain modified carbon nanotubes (CNTs) with super-hydrophobic characteristics. A novel super-hydrophobic/super-oleophilic polyurethane sponge (SH-MWCNTs@PU sponges) was achieved by performing further surface-modification with the super-hydrophobic CNTs via the immersion-coating process. The results showed that SH-MWCNTs@PU sponges exhibited excellent super-hydrophobic properties, with a water contact angle of 157.4 ± 1.1°, and water droplets roll-off angle of only 6.7°. In addition, its mechanical strength was greatly improved by the introduction of CNTs. Significantly, it exhibits excellent adsorption capability for different oils and organic solvents. The initial oil adsorption capacity is still maintained with a contact angle of 152.2° after 10 oil adsorption cycles, demonstrating good reusability of the SH-MWCNTs@PU sponges. The low-cost (the used MWCNTs-OH are industrial-grade), durable, and super-hydrophobic sponge is a promising material for oil–water separation with high efficiency and selectivity.
PetersonCH, RiceSD, ShortJW, Long-term ecosystem response to the Exxon Valdez oil spill. Science. 2003;302:2082–2086. doi: 10.1126/science.1084282
2.
DaltonT, JinD.Extent and frequency of vessel oil spills in US marine protected areas. Mar Pollut Bull. 2010;60:1939–1945. doi: 10.1016/j.marpolbul.2010.07.036
3.
AurellJ, GullettBK.Aerostat sampling of PCDD/PCDF emissions from the Gulf Oil spill in situ burns. Environ Sci Technol. 2010;44:9431–9437. doi: 10.1021/es103554y
4.
BrojeV, KellerAA.Effect of operational parameters on the recovery rate of an oleophilic drum skimmer. J Hazard Mater. 2007;148:136–143. doi: 10.1016/j.jhazmat.2007.02.017
5.
BrojeV, KellerAA.Improved mechanical oil spill recovery using an optimized geometry for the skimmer surface. Environ Sci Technol. 2006;40:7914–7918. doi: 10.1021/es061842m
6.
GeJ, ZhaoH-Y, ZhuH-W, Advanced sorbents for oil-spill cleanup: recent advances and future perspectives. Adv Mater. 2016;28:10459–10490. doi: 10.1002/adma.201601812
7.
BarryE, ManeAU, LiberaJA, Advanced oil sorbents using sequential infiltration synthesis. J Mater Chem A. 2017;5:2929–2935. doi: 10.1039/C6TA09014A
8.
MaQ, ChengH, FaneAG, Recent development of advanced materials with special wettability for selective oil/water separation. Small. 2016;12:2186–2202. doi: 10.1002/smll.201503685
9.
WangB, LiangW, GuoZ, Biomimetic super-lyophobic and super-lyophilic materials applied for oil/water separation: a new strategy beyond nature. Chem Soc Rev. 2015;44:336–361. doi: 10.1039/C4CS00220B
10.
BayatA, AghamiriSF, MohebA, Oil spill cleanup from sea water by sorbent materials. Chem Eng Technol. 2005;28:1525–1528. doi: 10.1002/ceat.200407083
11.
TsaiC-K, LiaoC-Y, WangHP, Pyrolysis of spill oils adsorbed on zeolites with product oils recycling. Mar Pollut Bull. 2008;57:895–898. doi: 10.1016/j.marpolbul.2008.02.041
12.
ChenJ, ZhangY, ChenC, Cellulose sponge with superhydrophilicity and high oleophobicity both in air and under water for efficient oil–water emulsion separation. Macromol Mater Eng. 2017;302:1700086. doi: 10.1002/mame.201700086
13.
RadeticMM, JocicDM, JovancicPM, Recycled wool-based nonwoven material as an oil sorbent. Environ Sci Technol. 2003;37:1008–1012. doi: 10.1021/es0201303
14.
AdebajoMO, FrostRL, KloproggeJT, Porous materials for oil spill cleanup: a review of synthesis and absorbing properties. J Porous Mat. 2003;10:159–170. doi: 10.1023/A:1027484117065
15.
LiL, LiB, SunH, Compressible and conductive carbon aerogels from waste paper with exceptional performance for oil/water separation. J Mater Chem A. 2017;5:14858–14864. doi: 10.1039/C7TA03511J
16.
NguyenDD, TaiN-H, LeeS-B, Superhydrophobic and superoleophilic properties of graphene-based sponges fabricated using a facile dip coating method. Energy Environ Sci. 2012;5:7908–7912. doi: 10.1039/c2ee21848h
17.
BiH, XieX, YinK, Spongy graphene as a highly efficient and recyclable sorbent for oils and organic solvents. Adv Funct Mater. 2012;22:4421–4425. doi: 10.1002/adfm.201200888
18.
WangD, LiD, LvP, Deposition of polytetrafluoroethylene nanoparticles on graphene oxide/polyester fabrics for oil adsorption. Surf Eng. 2019;35:426–434. doi: 10.1080/02670844.2018.1447271
ZhuD, Handschuh-WangS, ZhouX.Recent progress in fabrication and application of polydimethylsiloxane sponges. J Mater Chem A. 2017;5:16467–16497. doi: 10.1039/C7TA04577H
21.
ZhangJ, MengZ, LiuJ, Breath figure lithography for the construction of a hierarchical structure in sponges and their applications to oil/water separation. J Mater Chem A. 2017;5:16369–16375. doi: 10.1039/C7TA02751F
22.
CalcagnileP, FragouliD, BayerIS, Magnetically driven floating foams for the removal of oil contaminants from water. ACS Nano. 2012;6:5413–5419. doi: 10.1021/nn3012948
ZhangL, XuL, SunY, Robust and durable superhydrophobic polyurethane sponge for oil/water separation. Ind Eng Chem Res. 2016;55:11260–11268. doi: 10.1021/acs.iecr.6b02897
25.
TianQ, LiuQ, ZhouJ, Superhydrophobic sponge containing silicone oil-modified layered double hydroxide sheets for rapid oil-water separations. Colloids and Surfaces A. 2019;570:339–346. doi: 10.1016/j.colsurfa.2019.03.031
26.
WangY, ChenA, PengM, Preparation and characterization of a fluorizated kaolinemodified melamine sponge as an absorbent for efficient and rapid oil/water separation. J Clean Prod. 2019;217:308–316. doi: 10.1016/j.jclepro.2019.01.253
27.
LiM, BianC, YangG, Facile fabrication of water-based and non-fluorinated superhydrophobic sponge for efficient separation of immiscible oil/water mixture and water-in-oil emulsion. Chem Eng J. 2019;368:350–358. doi: 10.1016/j.cej.2019.02.176
28.
LiJ, XuC, ZhangY, Robust superhydrophobic attapulgite coated polyurethane sponge for efficient immiscible oil/water mixture and emulsion separation. J Mater Chem A. 2016;4:15546–15553. doi: 10.1039/C6TA07535E
29.
XiaC, LiY, FeiT, Facile one-pot synthesis of superhydrophobic reduced graphene oxidecoated polyurethane sponge at the presence of ethanol for oil-water separation. Chem Eng J. 2018;345:648–658. doi: 10.1016/j.cej.2018.01.079
30.
RahmaniZ, SamadiMT, KazemiA, Nanoporous graphene and graphene oxide-coated polyurethane sponge as a highly efficient, superhydrophobic, and reusable oil spill absorbent. J Environ Chem Eng. 2017;5:5025–5032. doi: 10.1016/j.jece.2017.09.028
31.
ChengQ, LiuC, LiuS.Fabrication of a robust superhydrophobic polyurethane sponge for oil–water separation. Surf Eng. 2019;35:403–410. doi: 10.1080/02670844.2018.1429204
32.
ShuaiQ, YangX, LuoY, A superhydrophobic poly(dimethylsiloxane)-TiO2 coated polyurethane sponge for selective absorption of oil from water. Mater Chem Phys. 2015;162:94–99. doi: 10.1016/j.matchemphys.2015.05.011
33.
CaoN, YangB, BarrasA, Polyurethane sponge functionalized with superhydrophobic nanodiamond particles for efficient oil/water separation. Chem Eng J. 2017;307:319–325. doi: 10.1016/j.cej.2016.08.105
34.
ZhangX, ZhiD, ZhuW, Facile fabrication of durable superhydrophobic SiO2/polyurethane composite sponge for continuous separation of oil from water. RSC Adv. 2017;7:11362–11366. doi: 10.1039/C7RA00020K
35.
WangZ, YangW, SunF.Construction of a superhydrophobic coating using triethoxyvinylsilane-modified silica nanoparticles. Surf Eng. 2019;35:418–425. doi: 10.1080/02670844.2018.1446575
36.
De VolderMFL, TawfickSH, BaughmanRH, Carbon nanotubes: present and future commercial applications. Science. 2013;339:535–539. doi: 10.1126/science.1222453
YanY, MiaoJ, YangZ, Carbon nanotube catalysts: recent advances in synthesis, characterization and applications. Chem Soc Rev. 2015;44:3295–3346. doi: 10.1039/C4CS00492B
39.
JiY, HuangL, HuJ, Polyoxometalate-functionalized nanocarbon materials for energy conversion, energy storage and sensor systems. Energy Environ Sci. 2015;8:776–789. doi: 10.1039/C4EE03749A
LingX-L, WeiY-Z, ZouL-M, Preparation and characterization of hydroxylated multi-walled carbon nanotubes. Colloids Surf A. 2013;421:9–15. doi: 10.1016/j.colsurfa.2012.12.046
46.
YangH, LiF, ShanC, Covalent functionalization of chemically converted graphene sheets via silane and its reinforcement. J Mater Chem. 2009;19:4632–4638. doi: 10.1039/b901421g
47.
HouS, SuS, KasnerML, Formation of highly stable dispersions of silane-functionalized reduced graphene oxide. Chem Phys Lett. 2010;501:68–74. doi: 10.1016/j.cplett.2010.10.051
48.
YuenS-M, MaC-CM, ChiangC-L, Silane-modified MWCNT/PMMA composites – preparation, electrical resistivity, thermal conductivity and thermal stability. Composites: Part A. 2007;38:2527–2535. doi: 10.1016/j.compositesa.2007.07.015
49.
QuR, WangX, WangZ, Metal accumulation and antioxidant defenses in the freshwater fish Carassius auratus in response to single and combined exposure to cadmium and hydroxylated multi-walled carbon nanotubes. J Hazard Mater. 2014;275:89–98. doi: 10.1016/j.jhazmat.2014.04.051
50.
LinB, ChenJ, LiZ-T, Superhydrophobic modification of polyurethane sponge for the oil-water separation. Surf Coat Tech. 2019;359:216–226. doi: 10.1016/j.surfcoat.2018.12.054
51.
ZhuX, ZhangK, WangC, Quantitative determination and toxicity evaluation of 2,4-dichlorophenol using poly(eosin Y)/hydroxylated multi-walled carbon nanotubes modified electrode. Sci Rep. 2016;6:38657. doi: 10.1038/srep38657
52.
ChenQ, de LeonA, AdvinculaRC.Inorganic−organic thiol−ene coated mesh for oil/water separation. ACS Appl Mater Interfaces. 2015;7:18566–18573. doi: 10.1021/acsami.5b04980
53.
LiX-M, ReinhoudtD, Crego-CalamaM.What do we need for a superhydrophobic surface? A review on the recent progress in the preparation of superhydrophobic surfaces. Chem Soc Rev. 2007;36:1350–1368. doi: 10.1039/b602486f
54.
GeM, CaoC, HuangJ, Rational design of materials interface at nanoscale towards intelligent oil–water separation. Nanoscale Horiz. 2018;3:235–260. doi: 10.1039/C7NH00185A
55.
ZhangL, LiH, LaiX, Thiolated graphene-based superhydrophobic sponges for oil-water separation. Chem Eng J. 2017;316:736–743. doi: 10.1016/j.cej.2017.02.030
