The effects of anisotropy and pre-strain on the low-cycle-fatigue properties of DP600 steel sheet under shear path were investigated. Fully reversed strain-controlled fatigue tests were performed along the 0° and 90° directions with the initial strain direction. The cyclic-loading amplitude determined whether the pre-strained material had a hardening process. The high dislocation density in the crystals of pre-strained material can promote the formation of low-energy substructures, obviously accelerating the cyclic-softening rate and reducing the fatigue life. Average plastic strain energy density was affected by the pre-straining state and loading direction and had a linear relationship with the strain amplitude. Overall, these results can be used to verify the calculation model of structural parts.
AliniaMMHosseinzadehSAAHabashiHR.Influence of central cracks on buckling and post-buckling behaviour of shear panels. Thin-Walled Struct. 2007; 45(4):422–431.
6.
WangZYZhangTChenYFatigue behaviour of slender corrugated webs subjected to plate breathing. Int J Fatigue. 2019; 122:46–60.
7.
PengYYeMSunWBuckling fatigue behavior of 2A97 Al-Li alloy stiffened panels under shear loading. Eng Fail Anal. 2021; 128:105575.
8.
WangBChenXSunXInteraction formulae for buckling and failure of orthotropic plates under combined axial compression/tension and shear. Chin J Aeronaut. 2022; 35(3):272–280.
9.
A W TMR DaviesRJBennettH.Fatigue shear strength of slender web plates. J Struct Eng. 1995; 121(10):1396–1401.
10.
GuoLLiaoFXuYExperimental method and failure mechanisms investigation for out-of-plane shear fatigue behavior of 3D woven composites. Int J Fatigue. 2020; 134:1–9.
11.
DasBSinghAPaulSKCorrelation between fatigue response of preformed bend DP600 steel specimen and wheel disc. Fatigue Fract Eng Mater Struct. 2020; 43(12):2842–2853.
12.
DasBSinghAKumar PaulS.Low cycle fatigue performance of DP600 steel under various pre-straining paths. Int J Fatigue. 2020; 132:105331.
13.
JinXJiSLiuCComparison of low cycle fatigue behavior of 304 stainless steels induced by tensile and torsional prestrain. Fatigue Fract Eng Mater Struct. 2020; 43(10):2247–2258.
14.
DasBSinghAAroraKSInfluence of pre-straining path on high cycle fatigue performance of DP 600 steel. Int J Fatigue. 2019; 126:369–380.
15.
LiaoJSousaJALopesABMechanical, microstructural behaviour and modelling of dual phase steels under complex deformation paths. Int J Plast. 2017; 93:269–290.
16.
TuoZYueZZhuangXComparison of two uncoupled ductile damage initiation models applied to DP900 steel sheet under various loading paths. Int J Damage Mech. 2021; 30(1):25–45.
17.
BrancoRCostaJDBorregoLPEffect of strain ratio on cyclic deformation behaviour of 7050-T6 aluminium alloy. Int J Fatigue. 2019; 129:105234.
18.
GhosalPRajAPaulSK.Influence of uniaxial and biaxial pre-straining on the low cycle fatigue performance of DP590 steel. Int J Fatigue. 2021; 149:106260.
19.
GustavssonAMelanderA.Variable-amplitude fatigue of a dual-phase sheet steel subjected to prestrain. Int J Fatigue. 1994; 16(7):503–509.
20.
PaulSKSivaprasadSDharSCyclic plastic deformation and cyclic hardening/softening behavior in 304LN stainless steel. Theor Appl Fract Mech. 2010; 54(1):63–70.
21.
LeQKangHKridliGEffect of prestrain paths on mechanical behavior of dual phase sheet steel. Int J Fatigue. 2009; 31(4):607–615.
22.
YinQSoyarslanCGünerAA cyclic twin bridge shear test for the identification of kinematic hardening parameters. Int J Mech Sci. 2012; 59(1):31–43.
23.
YuHYShenJY.Evolution of mechanical properties for a dual-phase steel subjected to different loading paths. Mater Des. 2014; 63:412–418.
24.
GhosalPPaulSKDasBNotch fatigue performance of DP600 steel under different pre-straining paths. Theor Appl Fract Mech. 2020; 108:102630.
25.
FloresPTuninettiVGillesGAccurate stress computation in plane strain tensile tests for sheet metal using experimental data. J Mater Process Technol. 2010; 210(13):1772–1779.
26.
HilditchTBTimokhinaIBRobertsonLTCyclic deformation of advanced high-strength steels: mechanical behavior and microstructural analysis. Metall Mater Trans A. 2009; 40(2):342–353.
27.
PaulSKStanfordNHilditchT.Effect of martensite volume fraction on low cycle fatigue behaviour of dual phase steels: experimental and microstructural investigation. Mater Sci Eng A. 2015; 638:296–304.
BrancoRCostaJDBertoFFatigue life assessment of notched round bars under multiaxial loading based on the total strain energy density approach. Theor Appl Fract Mech. 2018; 97:340–348.
30.
LambersHGRüsingCJNiendorfTOn the low-cycle fatigue response of pre-strained austenitic Fe61Mn24Ni6.5Cr8.5 alloy showing TWIP effect. Int J Fatigue. 2012; 40:51–60.
31.
GhosalPKumar PaulSRajA.Influence of uniaxial and biaxial pre-straining on the notch fatigue performance of DP590 steel. Theor Appl Fract Mech. 2021; 115:103072.
32.
DeyRTarafderSSivaprasadS.Influence of proportional and non-proportional loading on deformation behaviour of austenitic stainless steel-macro and micro analysis. Theor Appl Fract Mech. 2019; 100:342–353.
33.
BrewerLNOthonMAYoungLMMisorientation mapping for visualization of plastic deformation via electron back-scattered diffraction. Microsc Microanal. 2006; 12(1):85–91.
34.
PaulSK.Effect of martensite volume fraction on stress triaxiality and deformation behavior of dual phase steel. Mater Des. 2013; 50:782–789.
35.
TsipouridisPKollLKrempaszkyCOn the strength of grain and phase boundaries in ferritic-martensitic dual-phase steels. Int J Mater Res. 2011; 102(6):674–686.
36.
ArchieFLiXZaeffererS.Micro-damage initiation in ferrite-martensite DP microstructures: A statistical characterization of crystallographic and chemical parameters. Mater Sci Eng A. 2017; 701:302–313.
