The microstructural evolution of two model alloys, Fe–NiAl and Fe–NiAl–Mn, during aging at 500°C was investigated using atom probe tomography (APT). Vickers micro hardness measurements showed that the addition of Mn increased the hardness and decreased the time to reach the peak hardness. Both alloys exhibited a softening process at the initial stage of aging. The APT results showed that adding Mn increased the number density of NiAl nanoparticles significantly, and Mn atoms partitioned into the NiAl nanoparticles, occupying the Al sites preferentially. The precipitation of NiAl nanoparticles was accelerated by the addition of Mn because Mn increased the nucleation driving force for NiAl precipitates and reduced the strain energy for the nucleation.
HuangSGaoYAnKDeformation mechanisms in a precipitation-strengthened ferritic superalloy revealed by in situ neutron diffraction studies at elevated temperatures. Acta Mater. 2015; 83:137–148. doi: 10.1016/j.actamat.2014.09.053
2.
BrownLM.Strengthening Mechanisms in Crystal Plasticity, by Ali Argon. Contemp Phys. 2013; 54(6):306–307. doi: 10.1080/00107514.2013.857723
3.
WangJSMulhollandMDOlsonGBPrediction of the yield strength of a secondary-hardening steel. Acta Mater. 2013; 61(13):4939–4952. doi: 10.1016/j.actamat.2013.04.052
4.
LeitnerHSchoberMSchnitzerR.Splitting phenomenon in the precipitation evolution in an Fe–Ni–Al–Ti–Cr stainless steel. Acta Mater. 2010; 58(4):1261–1269. doi: 10.1016/j.actamat.2009.10.030
5.
HochanadelPWEdwardsGRRobinoCVHeat treatment of investment cast PH 13-8 Mo stainless steel: Part I. mechanical properties and microstructure. Metall Mater Trans A. 1994; 25(4):789–798. doi: 10.1007/BF02665455
6.
TengZKMillerMKGhoshGCharacterization of nanoscale NiAl-type precipitates in a ferritic steel by electron microscopy and atom probe tomography. Scr Mater. 2010; 63(1):61–64. doi: 10.1016/j.scriptamat.2010.03.013
7.
YangJMJengSMBainKMicrostructure and mechanical behavior of in-situ directional solidified NiAl/Cr(Mo) eutectic composite. Acta Mater. 1997; 45(1):295–308. doi: 10.1016/S1359-6454(96)00124-3
8.
NoebeRDBowmanRRNathalMV.Physical and mechanical properties of the B2 compound NiAl. Int Mater Rev. 1993; 38(4):193–232. doi: 10.1179/imr.1993.38.4.193
9.
GuoJT.Research progress of intermetallic NiAl alloys. J Central South Univ (Sci Technol.) 2007; 06:5–19.
10.
PingDHOhnumaMHirakawaYMicrostructural evolution in 13Cr–8Ni–2.5Mo–2Al martensitic precipitation-hardened stainless steel. Mater Sci Eng A J. 2005; 394(1–2):285–295. doi: 10.1016/j.msea.2004.12.002
11.
KainumaROhtaniHIshidaK.Effect of alloying elements on martensitic transformation in the binary NiAl(β) phase alloys. Metall Mater Trans A. 1996; 27(9):2445–2453. doi: 10.1007/BF02652338
12.
LiuCTFuCLChisholmMFMagnetism and solid solution effects in NiAl (40% Al) alloys. Prog Mater Sci. 2007; 52(2/3):352–370. doi: 10.1016/j.pmatsci.2006.10.014
13.
ThompsonRJZhaoJCHemkerKJ.Effect of ternary elements on a martensitic transformation in β-NiAl. Intermetallics. 2010; 18(5):0–802. doi: 10.1016/j.intermet.2009.12.017
14.
TengZKGhoshGMillerMKNeutron-diffraction study and modeling of the lattice parameters of a NiAl-precipitate-strengthened Fe-based alloy. J Acta Mater. 2012; 60(13-14):5362–5369. doi: 10.1016/j.actamat.2012.05.033
15.
VoNQLiebscherCHRawlingsMJSCreep properties and microstructure of a precipitation-strengthened ferritic Fe–Al–Ni–Cr alloy. J Acta Mater. 2014; 71:89–99. doi: 10.1016/j.actamat.2014.02.020
16.
LengWTianW.Precipitation characteristics by/in NiAl/Fe taken as matrix/precipitate in Ni-Al-Fe system. J. Rare Metals. 2009; 33(2):185–190.
17.
OlofChellmandu RivageJBSeidmanDN.Efficient sampling for three-dimensional atom probe microscopy data. Ultramicroscopy. 2005; 95(1-4):199–205.
18.
DmitrievaOPongeDIndenGChemical gradients across phase boundaries between martensiteand austenite in steel studied by atom probe tomography and simulation. Acta Mater. 2011; 59:364–374. doi: 10.1016/j.actamat.2010.09.042
19.
JiaoZBLuanJHZhangZWHigh-strength steels hardened mainly by nanoscale NiAl precipitates. J Scripta Mater. 2014; 87:45–48. doi: 10.1016/j.scriptamat.2014.05.006
20.
JiaoZBLuanJHMillerMKEffects of Mn partitioning on nanoscale precipitation and mechanical properties of ferritic steels strengthened by NiAl nanoparticles. J. Acta Mater. 2015; 84:283–291. doi: 10.1016/j.actamat.2014.10.065
21.
MillerMK.Atom probe tomography: analysis at the atomic level. New York: Kluwer Academic/Plenum; 2000.
22.
AlingerMJOdetteGRHoelzerDT.On the role of alloy composition and processing parameters in nanocluster formation and dispersion strengthening in nanostuctured ferritic alloys. Acta Mater. 2009; 57(2):392–406. doi: 10.1016/j.actamat.2008.09.025
23.
JiaoZBLuanJHMillerMKPrecipitate transformation from NiAl-type to Ni2AlMn-type and its influence on the mechanical properties of high-strength steels. Acta Mater. 2016; 110:31–43. doi: 10.1016/j.actamat.2016.03.024
24.
AaronsonHILegouesFK.Assessment of studies on homogeneous diffusional nucleation kinetics in binary metallic alloys. Metall. Mater. Trans A. 1992; 23(7):1915–1945. doi: 10.1007/BF02647541
