The phase transformation and microstructure evolution of pearlite heat-resistant steel during heating were observed with an ultra-high temperature confocal scanning laser microscope. The α-ferrite completely disappeared earlier than Fe3C during the formation of γ-austenite, which is inconsistent with the fact that the Fe3C should disappear completely earlier under equilibrium conditions. After the Fe3C + α→γ transformation, static recrystallisation of γ-austenite occurred, accompanied by the dissolution of cementite. During the γ→δ transformation, the δ-cell first precipitated at the triple point of the γ-austenite grain boundaries, and then the δ-cell platelet with one tip appeared in the γ-austenite grain. The law of δ/γ inter-phase boundaries was analysed based on inter-phase boundary types and element diffusion.
AdámovichVK.Effect of the Molybdenum content on the properties of pearlitic heat-resistant steels. Met Sci Heat Treat. 1977; 19:949–955. doi: 10.1007/BF00670164
2.
WangJSunJYuXMicrostructures and mechanical properties of 12Cr1MoVG Tube welded joints with/without post-weld heat treatment. J Mater Eng Perf. 2017; 26:4659–4666. doi: 10.1007/s11665-017-2936-8
3.
HeJXiongW.Effect of high temperature hot corrosion on the compression creep behavior of 12Cr1MoV Alloys. H Temp Mater Proc.2017; 36:1011–1023.
4.
DippenaarRJPhelanDJ.Delta-ferrite recovery structures in low-carbon steels. Metall Mater Trans, B. 2003; 34:495–501. doi: 10.1007/s11663-003-0016-y
5.
LiangGFWangCFangY.In situ observation of nucleation and growth of high-temperature delta phase in stainless steel AISI 304 during heating. Acta Metall Sin2006; 42:805–809.
6.
LiangGFWanCQWuJCIn situ observation of growth behavior and morphology of delta-ferrite as function of solidification rate in an AISI304 stainless steel. Acta Metall Sin.2006; 19:441–448. doi: 10.1016/S1006-7191(06)62085-1
7.
GriesserSBernhardCDippenaarR.Mechanism of the peritectic phase transition in Fe-C and Fe-Ni alloys under conditions close to chemical and thermal equilibrium. ISIJ Int2014; 54:466–473. doi: 10.2355/isijinternational.54.466
8.
GriesserSBernhardCDippenaarR.Effect of nucleation undercooling on the kinetics and mechanism of the peritectic phase transition in steel. Acta Mater2014; 81:111–120. doi: 10.1016/j.actamat.2014.08.020
LiuNLiuFYangGCPeritectic solidification of undercooled Fe-Co alloys. J. Alloys Compd. 2008; 465:391–395. doi: 10.1016/j.jallcom.2007.10.120
11.
WangYYuHLiuYEffects of annealing treatment on microstructure and mechanical property of cold-drawn 316L stainless steel fibers. Mater. Sci. Eng. A. 2018; 714:93–104. doi: 10.1016/j.msea.2017.12.064
12.
PandeyCMahapatraMMKumarPMicrostructure characterization and charpy toughness of P91 weldment for as-welded, post-weld heat treatment and normalizing and tempering heat treatment. Met Mater Int.2017; 23:900–914. doi: 10.1007/s12540-017-6850-2
13.
ZhuXLiWHsuTY.Improved resistance to hydrogen embrittlement in a high-strength steel by quenching–partitioning–tempering treatment. Scr Mater.2015; 97:21–24. doi: 10.1016/j.scriptamat.2014.10.030
14.
YangYTanHZhangZEffect of annealing temperature on the pitting corrosion behavior of UNS S82441 duplex stainless steel. Corr.2013; 69:167–173. doi: 10.5006/0717
15.
GuthrieRILJonasJJ.ASM handbook: properties and selection: irons, steels and high performance alloys. 10th edn Vol. 1, 115–116; Materials Park ( OH): ASM International; 1990.
16.
BanerjeeKMilitzerMPerezMNonisothermal austenite grain growth kinetics in a microalloyed x80 linepipe steel. Metall Mater Trans A. 2010; 41A:3161–3172. doi: 10.1007/s11661-010-0376-2
17.
CuiZQTanYC.Metallography and heat treatment. Beijing: China Machine Press; 2000; 114–116.
18.
KhalajGYoozbashizadehHKhodabandehAAustenite grain growth modelling in weld heat affected zone of Nb/Ti microalloyed linepipe steel. Mater Sci Technol2014; 30:424–433. doi: 10.1179/1743284713Y.0000000364
19.
AkbayTReedRCAtkinsonC.Modelling reaustenitisation from ferrite/cementite mixtures in Fe-C steels. Acta Metall Mater.1994; 42:1469–1480. doi: 10.1016/0956-7151(94)90165-1
20.
MiyamotoGUsukiHLiZDEffects of Mn, Si and Cr addition on reverse transformation at 1073 K from spheroidized cementite structure in Fe-0.6 mass% C alloy. Acta Mater2010; 58:4492–4502. doi: 10.1016/j.actamat.2010.04.045
21.
AkbayTAtkinsonC.The influence of diffusion of carbon in ferrite as well as in austenite on a model of reaustenitization from ferrite/cementite mixtures in Fe-C steels. J Mater Sci1996; 31:2221–2226. doi: 10.1007/BF01152931
22.
YinHEmiTShibataH.Morphological instability of δ-ferrite/γ-austenite interphase boundary in low carbon steels. Acta Mater1999; 47:1523–1535. doi: 10.1016/S1359-6454(99)00022-1
23.
SiWULiXCJuanZ.Influence of Nb micro-alloying on austenite nucleation and growth in high speed railway wheels steel. Iron Steel. 2015; 50:100–107.
24.
XuZZhaoLC.Principle of solid metal phase transition. Beijing: science press; 2004; 41–43.
25.
NakaiKOhmoriY.Pearlite to austenite transformation in a Fe-2.6Cr-1C alloy. Acta Mater. 1999; 47:2619–2632. doi: 10.1016/S1359-6454(99)00142-1
26.
SunYHZhaoYLiX.Effects of heating and cooling rates on δ↔γ phase transformations in duplex stainless steel by in situ observation. Ironmak Steelmak.2019; 46:1–8. doi: 10.1080/03019233.2019.1659657
27.
ZhaoYSunYHLiX.In-situ observation of δ↔γ phase transformations in duplex stainless steel containing different nitrogen contents. ISIJ Int. 2017; 57:1637–1644. doi: 10.2355/isijinternational.ISIJINT-2017-125
