The microstructural evolution of an overaged Cu-4wt-%Ti alloy associated with surface mechanical attrition treatment (SMAT) has been studied by X-ray diffraction, scanning electron microscope and transmission electron microscopy. The results show that β-Cu4Ti precipitates in the topmost surface layer were dissolved after SMAT, and Cu solid solution phase with a fine grain size of approximately 25 nm was observed. Dislocation activities were the main deformation mechanism of lamellar structure in the overaged Cu–4wt-%Ti alloy. The twinning in lamellar Cu phase was inhibited by the β-Cu4Ti precipitates.
BachmaierASchmauchJAboulfadlHOn the process of co-deformation and phase dissolution in a hard-soft immiscible Cu-Co alloy system during high-pressure torsion deformation. Acta Mater. 2016; 115:333–346. doi: 10.1016/j.actamat.2016.06.010
EdalatiKUehiroRFujiwaraKUltra-severe plastic deformation: evolution of microstructure, phase transformation and hardness in immiscible magnesium-based systems. Mater Sci Eng A. 2017; 701:158–166. doi: 10.1016/j.msea.2017.06.076
4.
ZhangHWOhsakiSMitaoSMicrostructural investigation of white etching layer on pearlite steel rail. Mater Sci Eng A. 2006; 421(1):191–199. doi: 10.1016/j.msea.2006.01.033
5.
TaniyamaATakayamaTAraiMStructure analysis of ferrite in deformed pearlitic steel by means of X-ray diffraction method with synchrotron radiation. Scr Mater. 2004; 51(1):53–58. doi: 10.1016/j.scriptamat.2004.03.018
6.
TeplovVAPiluginVPGavikoVSNon-equilibrium solid solution and nanocrystal structure of Fe–Cu alloy after plastic deformation under pressure. Philos Mag Part B. 1993; 68(68):877–881. doi: 10.1080/13642819308217944
7.
StolyarovVVLapovokRBrodovaIGUltrafine-grained Al–5 wt. % Fe alloy processed by ECAP with backpressure. Mater Sci Eng A. 2003; 357(1):159–167. doi: 10.1016/S0921-5093(03)00215-6
8.
SauvageXWetscherFPareigeP.Mechanical alloying of Cu and Fe induced by severe plastic deformation of a Cu–Fe composite. Acta Mater. 2005; 53(7):2127–2135. doi: 10.1016/j.actamat.2005.01.024
9.
StraumalBBBaretzkyBMazilkinAAFormation of nanograined structure and decomposition of supersaturated solid solution during high pressure torsion of Al–Zn and Al–Mg alloys. Acta Mater. 2004; 52(15):4469–4478. doi: 10.1016/j.actamat.2004.06.006
10.
MazilkinAAStraumalBBRabkinESoftening of nanostructured Al–Zn and Al–Mg alloys after severe plastic deformation. Acta Mater. 2006; 54(15):3933–3939. doi: 10.1016/j.actamat.2006.04.025
11.
StraumalBBMazilkinAARabkinEDeformation-driven formation of equilibrium phases in the Cu–Ni alloys. J Mater Sci. 2012; 47(1):360–367. doi: 10.1007/s10853-011-5805-0
12.
SauvageXPippanR.Nanoscaled structure of a Cu–Fe composite processed by high-pressure torsion. Mater Sci Eng A. 2005; 410(12):345–347. doi: 10.1016/j.msea.2005.08.122
13.
SauvageXGenevoisCCostaGDAtomic scale characterization of deformation-induced interfacial mixing in a Cu/V nanocomposite wire. Scr Mater. 2009; 61(6):660–663. doi: 10.1016/j.scriptamat.2009.06.007
14.
KorznikovAVTramGDimitrovOThe mechanism of nanocrystalline structure formation in NiAl during severe plastic deformation. Acta Mater. 2001; 49(4):663–671. doi: 10.1016/S1359-6454(00)00345-1
15.
RentenbergerCKarnthalerHP.Extensive disordering in long-range-ordered CuAu induced by severe plastic deformation studied by transmission electron microscopy. Acta Mater. 2008; 56(11):2526–2530. doi: 10.1016/j.actamat.2008.01.035
Cepeda-JiménezCMGarcía-InfantaJMZhilyaevAPInfluence of the thermal treatment on the deformation-induced precipitation of a hypoeutectic Al–7wt% Si casting alloy deformed by high-pressure torsion. J. Alloy Compound. 2011; 509(3):636–643. doi: 10.1016/j.jallcom.2010.09.122
SergueevaAVSongCValievRZStructure and properties of amorphous and nanocrystalline NiTi prepared by severe plastic deformation and annealing. Mater Sci Eng A. 2003; 339(1):159–165. doi: 10.1016/S0921-5093(02)00122-3
20.
SauvageXRenaudLDeconihoutBSolid state amorphization in cold drawn Cu/Nb wires. Acta Mater. 2001; 49(3):389–394. doi: 10.1016/S1359-6454(00)00338-4
21.
GlezerAMPlotnikovaMPShalimovaAVSevere plastic deformation of amorphous alloys: I. structure and mechanical properties. Bull Russ Acad Sci Phys. 2009; 73(9):1233–1239. doi: 10.3103/S1062873809090123
22.
KovácsZHenitsPZhilyaevAPDeformation induced primary crystallization in a thermally non-primary crystallizing amorphous Al85Ce8Ni5Co2 alloy. Scr Mater. 2006; 54(10):1733–1737. doi: 10.1016/j.scriptamat.2006.02.004
23.
OhsakiSKatoSTsujiNBulk mechanical alloying of Cu–Ag and Cu/Zr two-phase microstructures by accumulative roll-bonding process. Acta Mater. 2007; 55(8):2885–2895. doi: 10.1016/j.actamat.2006.12.027
HuangWLiuZXiaLSevere plastic deformation-induced dissolution of θ” particles in Al–Cu binary alloy and subsequent nature aging behavior. Mater Sci Eng A. 2012; 556:801–806. doi: 10.1016/j.msea.2012.07.070
26.
FerneeHNairnJAtrensA.Quaternary Cu-0.7%Cr-0.3%Fe-X alloys. J Mater Sci. 2001; 36(19):4763–4777. doi: 10.1023/A:1017991408193
27.
KorznikovAVIvanisenkoYVLaptionokDVInfluence of severe plastic deformation on structure and phase composition of carbon steel. Nanostruct Mater. 1994; 4(2):159–167. doi: 10.1016/0965-9773(94)90075-2
28.
MurayamaMHoritaZHonoK.Microstructure of two-phase Al–1.7 at% Cu alloy deformed by equal-channel angular pressing. Acta Mater. 2001; 49(1):21–29. doi: 10.1016/S1359-6454(00)00308-6
29.
LiuZXuCHanXThe dissolution behavior of θ′ phase in Al–Cu binary alloy during equal channel angular pressing and multi-axial compression. Mater Sci Eng A. 2010; 527(16):4300–4305. doi: 10.1016/j.msea.2010.03.046
30.
StraumalBBKilmametovARKornevaAPhase transitions in Cu-based alloys under high pressure torsion. J. Alloy Compound. 2016; 707:20–26. doi: 10.1016/j.jallcom.2016.12.057
31.
StraumalBBKilmametovARIvanisenkoYPhase transitions during high pressure torsion of Cu-Co alloys. Mater Lett. 2014; 118(3):111–114. doi: 10.1016/j.matlet.2013.12.042
32.
KornevaAStraumalBKilmametovAPhase transformations in a Cu-Cr alloy induced by high pressure torsion. Mater Charact. 2016; 114:151–156. doi: 10.1016/j.matchar.2016.02.017
33.
StraumalBBPontikisVKilmametovARCompetition between precipitation and dissolution in Cu–Ag alloys under high pressure torsion. Acta Mater. 2017; 122:60–71. doi: 10.1016/j.actamat.2016.09.024
34.
StraumalBBKilmametovARMazilkinAATransformations of Cu(in) supersaturated solid solutions under high-pressure torsion. Mater Lett. 2015; 138:255–258. doi: 10.1016/j.matlet.2014.10.009
35.
SunSHYinFLiuYFDeformation-induced dissolution of copper precipitation in 1.5wt%Cu-bearing antibacterial Fe-17wt%Cr alloy during plastic deformation process. Mater Des. 2018; 157:469–477. doi: 10.1016/j.matdes.2018.08.014
36.
SoffaWALaughlinDE.High-strength age hardening copper–titanium alloys: redivivus. Prog Mater Sci. 2004; 49(3):347–366. doi: 10.1016/S0079-6425(03)00029-X
37.
WeiHWeiYHHouLFCorrelation of ageing precipitates with the corrosion behaviour of Cu-4 wt.% Ti alloys in 3.5 wt.% NaCl solution. Corros Sci. 2016; 111:382–390. doi: 10.1016/j.corsci.2016.05.029
38.
HouLFWeiYHLiuBSMicrostructure evolution of AZ91D induced by high energy shot peening. Trans Nonferr Metal Soc China. 2008; 18(5):0–1057. doi: 10.1016/S1003-6326(08)60180-6
39.
TaoNRSuiMLLuJSurface nanocrystallization of iron induced by ultrasonic shot peening. Nanostruct Mater. 1999; 11(4):433–440. doi: 10.1016/S0965-9773(99)00324-4
40.
WeiHCuiYCCuiHQEvolution of grain refinement mechanism in Cu-4wt.%Ti alloy during surface mechanical attrition treatment. J Alloys Compd. 2018; 763:835–843. doi: 10.1016/j.jallcom.2018.06.043
41.
LiYLiCWuYMicrostructural evolution and phase transformation of Ni3Al-based superalloys after thermal exposure. Vacuum. 2020; 171:1–7.
42.
ChristianJWMahajanS.Deformation twinning. Prog Mater Sci. 1995; 39(1):1–157. doi: 10.1016/0079-6425(94)00007-7
43.
FerneeHNairnJAtrensA.Precipitation hardening of Cu-Fe-Cr alloys part I mechanical and electrical properties. J Mater Sci. 2001; 36(11):2711–2719. doi: 10.1023/A:1017916930459
