The mechanical behaviour of Mg–7Gd–5Y–1.2Nd–0.5Zr (wt. %) alloy with ultrafine grains was measured by split Hopkinson pressure bar method under the strain rates of 1000, 1500, and 2000 s−1 at room temperature. Dynamic tests were carried out along extrusion direction (ED), transverse direction (TD), and normal direction (ND). The results demonstrated that the flow stress increased with the increase of strain rate, showing a positive strain rate strengthening effect. There was no obvious anisotropy in dynamic compression along ED, TD, and ND, which was caused by rare earth elements and multi-pass deformation. This led to the adoption of plastic deformation mode dominated by non-basal slip and participated by tension twinning.
FuruyaH, KogisoN, MatunagaS, Applications of magnesium alloys for aerospace structure systems. Mater Sci Forum. 2000;350–351:341–348. doi: 10.4028/www.scientific.net/MSF.350-351.341
5.
DingW, FuP, PengL, Advanced magnesium alloys and their applications in aerospace. Spacecra Environ Eng. 2011;28(2):103–109.
6.
KleinerS, UggowitzerPJ.Mechanical anisotropy of extruded Mg–6%Al–1%Zn alloy. Mater Sci Eng A. 2004;379(1–2):258–263. doi: 10.1016/j.msea.2004.02.020
7.
BallE.A, PrangnellP.B.Tensile-compressive yield asymmetries in high strength wrought magnesium alloys. Scr Metall Mater. 1994;31(2):111–116. doi: 10.1016/0956-716X(94)90159-7
8.
BohlenJ, NurnbergMR, SennJW, The texture and anisotropy of magnesium zinc-rare earth alloy sheets. Acta Mater. 2007;55(6):2101–2112. doi: 10.1016/j.actamat.2006.11.013
9.
YinDL, WangJT, LiuJQ, On tension-compression yield asymmetry in an extruded Mg–3Al–1Zn alloy. J Alloys Compd. 2009;478(1–2):789–795. doi: 10.1016/j.jallcom.2008.12.033
10.
YinSM, WangCH, DiaoYD, Influence of grain size and texture on the yield asymmetry of Mg–3Al–1Zn alloy. J Mater Sci Technol. 2011;27(1):29–34. doi: 10.1016/S1005-0302(11)60021-2
11.
YongjunL, KuiZ, XinggangL.Mechanical properties and fracture behavior of EW75 alloy under different conditions. 2011 Summary of Papers of China Mater Semin. 2011.
12.
MaoPL, YuJC, LiuZ, Dynamic mechanical property and failure behavior of extruded Mg–Gd–Y alloy under high strain rate compression. Trans Nonferrous Met Sco China. 2013;23(4):889–897. doi: 10.1016/S1003-6326(13)62544-3
13.
ZhangF, LiuZ, MaoP, The modified temperature term on Johnson Cook model for AZ31 magnesium alloy. Materialwiss und Werkst. 2018;49(8):1040–1052. doi: 10.1002/mawe.201700264
14.
YanyuL, PingliM, ZhengL, Theoretical Calculation of Schmid Factor and Its Application under high strain rate deformation in magnesium alloys. Acta Metall Sin. 2018;54(6):950–958.
15.
LiuY, MaoP, FengZ, Effect of temperature on the anisotropy of AZ31 magnesium alloy rolling sheet under high strain rate deformation. Philos Mag. 2018;98(12):1–19. doi: 10.1080/14786435.2018.1427896
16.
UlaciaI, DudamellNV, GálvezF, Mechanical behavior and microstructural evolution of a Mg AZ31 sheet at dynamic strain rates. Acta Mater. 2010;58:2988–2998. doi: 10.1016/j.actamat.2010.01.029
17.
WangYN, HuangJC.Texture analysis in hexagonal materials. Mater Chem Phys. 2003;81(1):11–26. doi: 10.1016/S0254-0584(03)00168-8
18.
JiangL, JonasJJ, MishraRK, Twinning and texture development in two Mg alloys subjected to loading along three different strain paths. Acta Mater. 2007;55:3899–3910. doi: 10.1016/j.actamat.2007.03.006
19.
WatanabeH, IshikawaK.Effect of texture on high temperature deformation behavior at high strain rates in a Mg-3Al-1Zn alloy. Mater Sci Eng A. 2009;523(1–2):304–311. doi: 10.1016/j.msea.2009.06.019
20.
BarnettMR.A Taylor model based description of the proof stress of magnesium AZ31 during hot working. Metall Mater Trans A. 2003;34(9):1799–1806. doi: 10.1007/s11661-003-0146-5
21.
BurkeEC, HibbardWR.Plastic deformation of magnesium single crystals. JOM. 1952;4(3):295–303. doi: 10.1007/BF03397694
22.
WanG, WuBL, ZhangYD, Anisotropy of dynamic behavior of extruded AZ31 magnesium alloy. Mater Sci Eng A. 2010;527(12):2915–2924. doi: 10.1016/j.msea.2010.01.023
23.
BarnettM.R, KeshavarzZ, BeerAG, Influence of grain size on the compressive deformation of wrought Mg–3Al–1Zn. Acta Mater. 2004;52(17):5093–5103. doi: 10.1016/j.actamat.2004.07.015
24.
YangQ, GhoshAK.Production of ultrafine-grain microstructure in Mg alloy by alternate biaxial reverse corrugation. Acta Mater. 2006;54(19):5147–5158. doi: 10.1016/j.actamat.2006.06.045
25.
YangQ, GhoshAK.Formability of ultrafine-grain Mg Alloy AZ31B at warm temperatures. Metall Mater Trans A. 2008;39(11):2781–2796. doi: 10.1007/s11661-008-9551-0
