This investigation focuses on deformation-induced plasticity in Invar-type steel alloys. The effect is being studied in an austenitic model alloy, containing 30 wt-% of nickel. Its temperature dependent mechanical properties are being presented. Furthermore, the martensitic phase content has been determined by magnetic means in an alloy with two ferromagnetic phases for the first time. The results show that the α′-martensite formation within the austenitic phase with primarily wavy glide mechanism allows an increase in ductility of around 10% at the Msσ temperature of −5°C. This is the point of maximum uniform elongation. Near the Ms temperature, a microstructure of 70 vol.-% deformation-induced α′-martensite can be achieved.
TalonenJ, AspegrenP, HänninenH.Comparison of different methods for measuring strain induced α-martensite content in austenitic steels. Mater Sci Tech. 2004;20(12):1506–1512. doi: 10.1179/026708304X4367
2.
SpencerK, VéronM, Yu-ZhangK, The strain induced martensite transformation in austenitic stainless steels: part 1 – influence of temperature and strain history. Mater Sci Tech. 2009;25(1):7–17. doi: 10.1179/174328408X293603
3.
JacquesPJ, AllainS, BouazizO, On measurement of retained austenite in multiphase TRIP steels – results of blind round robin test involving six different techniques. Mater Sci Tech. 2009;25(1):567–574. doi: 10.1179/174328408X353723
4.
WendlerM, MolaJ, KrügerL, Experimental quantification of the austenite-stabilizing effect of Mn in CrMnNi As-cast stainless steels. St Res Int. 2014;85(5):803–810. doi: 10.1002/srin.201300271
5.
WendlerM, HauserM, FabrichnayaO, Thermal and deformation-induced phase transformation behavior of Fe-15Cr-3Mn-3Ni-0.1N-(0.05-0.25)C austenitic and austenitic–martensitic cast stainless steels. Mater Sci Eng A. 2015;645(10):28–39. doi: 10.1016/j.msea.2015.07.084
6.
MolaJ, WendlerM, WeißA, Segregation-induced enhancement of low-temperature tensile ductility in a cast high-nitrogen austenitic stainless steel exhibiting deformation-induced α Martensite formation. Metall Mater Trans A. 2015;46(4):1450–1454. doi: 10.1007/s11661-015-2782-y
7.
WeißA, GutteH, MolaJ.Contributions of ϵ and α TRIP effects to the strength and ductility of AISI 304 (X5CrNi18-10) austenitic stainless steel. Metall Mater Trans A. 2015;46(1):1–11.
8.
HauserM, WendlerM, WeißA, Modeling of deformation mechanisms in Fe-19Cr-3Mn-4Ni-0.15N-0.17C cast austenitic steel with TRIP/TWIP effects. Proceedings of the Asia Steel International Conference; Yokohama, Japan. The Iron and Steel Institute of Japan; 2015. p. 100–101.
9.
WendlerM, MolaJ, ReichelB, Temperature dependence of properties in an Fe-19Cr-4Ni-3Mn-0.15N-0.2C austenitic cast steel. Proceedings of the High Manganese Steel. 2nd International Conference; Aachen, Germany. 2014 Aug 31; 2014. p. 407–410.
10.
HauserM, WendlerM, Ghosh ChowdhuryS, Quantification of deformation-induced α′-martensite in Fe–19Cr–3Mn–4Ni–0.15C–0.15N austenitic steel by in situ magnetic measurements. Mater Sci Tech. 2015;31(12):1473–1478. doi: 10.1179/1743284714Y.0000000731
11.
BérangerG, DuffautF, MorletJ, The iron nickel alloys. A hundred years after the discovery of invar. Paris: Lavoisier Publishing; 1996.
ParkWS, ChunMS, HanMS, Comparative study on mechanical behavior of low temperature application materials for ships and offshore structures: part I – experimental investigations. Mater Sci Eng A. 2011;528(18):5790–5803. doi: 10.1016/j.msea.2011.04.032
14.
MenshikovAZ.Invar effect by local moment model. J Magn Magn Mater. 1977;5:188–195. doi: 10.1016/0304-8853(77)90159-7
15.
MoroniEG, JarlborgT.Invar properties in Fe-Ni system from band theory. Physica B. 1989;161:115–120. doi: 10.1016/0921-4526(89)90115-4
16.
MoruzziVL.Theory of invar. Solid State Comm. 1992;83(9):739–743. doi: 10.1016/0038-1098(92)90155-3
17.
ShigaM.Invar alloys. Curr Opin Solid State Mater Sci. 1996;1:340–348. doi: 10.1016/S1359-0286(96)80023-4
18.
TinoY.The cause of invar characteristic in Fe-Ni alloys. J Magn Magn Mater. 1985;54–57:1067–1068. doi: 10.1016/0304-8853(86)90384-7
PepperhoffW, AcetM.Constitution and magnetism of iron and its alloys. Berlin: Springer; 2001.
22.
WeißA, GutteH, MolaJ.Contributions of ϵ and α′ TRIP effects to the strength and ductility of AISI 304 (X5CrNi18-10) austenitic stainless steel. Metall Mater Trans A. 2015;46(2):1–11.
23.
MolaJ, LuanG, BrochnowD, Tempering of martensite and subsequent redistribution of Cr, Mn, Ni, Mo, and Si between cementite and martensite studied by magnetic measurements. Met Ma Trans A. 2017;48(12):5805–5812. doi: 10.1007/s11661-017-4374-5
24.
WolfS.Temperatur- und dehnratenabhängiges Werkstoffverhalten einer hochlegierten CrMnNi-TRIP/TWIP-Stahlgusslegierung unter einsinniger Zug- und Druckbeanspruchung [Temperature and strain rate dependent material behaviour of a high alloyed CrMnNi-TRIP/TWIP cast steel alloy under uniaxial tensile and compressive load] [[Dissertation]. Herzogenrath: Shaker;2012 . German.
25.
BrofmanPJ, AnsellGS.On the effect of carbon on the stacking fault energy of austenitic stainless steels. Metall Trans A. 1978;9(6):879ff. doi: 10.1007/BF02649799
26.
DaiQX, WangAD, ChengXN, Stacking fault energy of cryogenic austenitic steels. Chin Phys. 2002;11(6):596ff. doi: 10.1088/1009-1963/11/6/315
27.
RhodesCG, ThompsonAW.The composition dependence of stacking fault energy in austenitic stainless steels. Metall Trans A. 1977;8(12):1901ff. doi: 10.1007/BF02646563
28.
SchrammRE, ReedRP.Stacking fault energies of seven commercial austenitic stainless steels. Metall Trans A. 1975;6(7):1345ff. doi: 10.1007/BF02641927
29.
BrackeL, MertensG, PenningJ.Influence of phase transformations on the mechanical properties of high-strength austenitic Fe-Mn-Cr steel. Metall Mater Trans A. 2006;37(2):307–317. doi: 10.1007/s11661-006-0002-5
30.
LiJ, ZhengW, JiangQ.Stacking fault energy of iron-base shape memory alloys. Mater Let. 1999;38(4):275–277. doi: 10.1016/S0167-577X(98)00172-4
