High-entropy alloys (HEAs) have emerged as a new alloy system, with many attractive properties. Among the fabrication routes, mechanical alloying followed by sintering, have been widely used. However, sintering mechanisms of HEA powders have not yet been fully understood. This work attempts to understand the sintering kinetics of CoCrFeNiMn HEA powders. A comparative study has been done on CoCrFeNiMn alloy powders on as-milled and annealed conditions, which revealed different sintering behaviours. Decreasing densification rates with increasing activation energies were observed through dilatometry after the annealing treatment. Combined diffusion coefficients and activation energies analysed through the sintering models indicate that during sintering of the as-milled powder, mass transport occurred through several modes. On the other hand, the annealed CoCrFeNiMn alloy powder (which was nearly single phase) clearly reveals volume diffusion as the controlling mechanism during sintering. It was characterised with large activation energy.
Special theme block on high entropy alloys, guest edited by Paula Alvaredo Olmos, Universidad Carlos III de Madrid, Spain, and Sheng Guo, Chalmers University, Gothenburg, Sweden.
CantorB, ChangITH, KnightP, . Microstructural development in equiatomic multicomponent alloys. Mater Sci Eng A. 2004;375–377:213–218. doi: 10.1016/j.msea.2003.10.257
2.
YehJ-W, ChenS-K, LinS-J, . Nanostructured high-entropy alloys with multiple principal elements: novel alloy design concepts and outcomes. Adv Eng Mater. 2004;6(5):299–303. doi: 10.1002/adem.200300567
3.
YehJ-W.Recent progress in high-entropy alloys. Ann Chim Sci Mat. 2006;31:633–648. doi: 10.3166/acsm.31.633-648
4.
MiracleDB, SenkovON.A critical review of high entropy alloys and related concepts. Acta Mater. 2017;122:448–511. doi: 10.1016/j.actamat.2016.08.081
5.
ZhangY, ZuoTT, TangZ, . Microstructures and properties of high-entropy alloys. Prog Mater Sci. 2014;61:1–93. doi: 10.1016/j.pmatsci.2013.10.001
GuoS, LiuCT.Phase stability in high entropy alloys: formation of solid-solution phase or amorphous phase. Prog Nat Sci Mater Int. 2011;21:433–446. doi: 10.1016/S1002-0071(12)60080-X
8.
ZhangZ, MaoMM, WangJ, . Nanoscale origins of the damage tolerance of the high-entropy alloy CrMnFeCoNi. Nat Commun. 2015;6:10143. doi: 10.1038/ncomms10143
9.
ZhangY, ZuoT, ChengY, High-entropy alloys with high saturation magnetization, electrical resistivity, and malleability. Sci Rep. 2013;3:1455. doi: 10.1038/srep01455
10.
LiX, TianF, SchöneckerS, Ab initio-predicted micro-mechanical performance of refractory high-entropy alloys. Sci Rep. 2015;5:12334. doi: 10.1038/srep12334
PradeepKG, WanderkaN, ChoiP, . Atomic-scale compositional characterization of a nanocrystalline AlCrCuFeNiZn high-entropy alloy using atom probe tomography. Acta Mater. 2013;61:4696–4706. doi: 10.1016/j.actamat.2013.04.059
15.
SenkovON, MillerJD, MiracleDB, Accelerated exploration of multi-principal element alloys with solid solution phases. Nat Commun. 2015;6:6529. doi: 10.1038/ncomms7529
16.
LiuWH, WuY, HeJY, . Grain growth and the Hall-Petch relationship in a high-entropy FeCrNiCoMn alloy. Scripta Mater. 2013;68:526–529. doi: 10.1016/j.scriptamat.2012.12.002
17.
ZaddachAJ, NiuC, KochCC, . Mechanical properties and stacking fault energies of NiFeCrCoMn high-entropy alloy. J Mater Met Mater Sci. 2013;65:1780–1789. doi: 10.1007/s11837-013-0771-4
18.
LaurentM, AkhatovaA, PerrièreL, . Insights into the phase diagram of the CrMnFeCoNi high entropy alloy. Acta Mater. 2015;88:355–365. doi: 10.1016/j.actamat.2015.01.068
19.
BhattacharjeePP, SathiarajGD, ZaidM, . Microstructure and texture evolution during annealing of equiatomic CoCrFeMnNi high-entropy alloy. J Alloy Compd. 2014;587:544–552. doi: 10.1016/j.jallcom.2013.10.237
20.
SathiarajGD, AhmedMZ, BhattacharjeePP.Microstructure and texture of heavily cold-rolled and annealed fcc equiatomic medium to high entropy alloys. J Alloy Compd. 2016;664:109–119. doi: 10.1016/j.jallcom.2015.12.172
21.
LaplancheG, GadaudP, HorstO, . Temperature dependencies of the elastic moduli and thermal expansion coefficient of an equiatomic single-phase CoCrFeMnNi high-entropy alloy. J Alloy Compd. 2015;623:348–353. doi: 10.1016/j.jallcom.2014.11.061
22.
GuoS, NgC, LiuCT.Anomalous solidification microstructures in Co-free AlxCrCuFeNi2 high-entropy alloys. J Alloys Compd. 2013;557:77–81. doi: 10.1016/j.jallcom.2013.01.007
23.
YeGX, WuB, ZhangCH, . Study of solidification and microstructures of multi-principal high-entropy alloy FeCoNiCrMn by using experiments and simulation. Adv Mater Res. 2012;399:1746–1749.
24.
GuoS, NgC, WangZ, . Solid solutioning in equiatomic alloys: limit set by topological instability. J Alloy Compd. 2014;583:410–413. doi: 10.1016/j.jallcom.2013.08.213
25.
PraveenS, MurtyBS, KottadaRS.Alloying behavior in multi-component AlCoCrCuFe and NiCoCrCuFe high entropy alloys. Mater Sci Eng A. 2012;534:83–89. doi: 10.1016/j.msea.2011.11.044
26.
FuZ, ChenW, XiaoH, . Fabrication and properties of nanocrystalline Co0.5FeNiCrTi0.5 high entropy alloy by MA-SPS technique. Mater Des. 2013;44:535–539. doi: 10.1016/j.matdes.2012.08.048
27.
YuhuF, YunpengZ, HongyanG, . Alcrnifexmo0.2CoCu high entropy alloys prepared by powder metallurgy. Rare Met Mater Eng. 2013;42:1127–1129. doi: 10.1016/S1875-5372(13)60074-0
28.
JiW, WangW, WangH, . Alloying behavior and novel properties of CoCrFeNiMn high-entropy alloy fabricated by mechanical alloying and spark plasma sintering. Intermetallics. 2015;56:24–27. doi: 10.1016/j.intermet.2014.08.008
29.
VaralakshmiS, KamarajM, MurtyBS.Synthesis and characterization of nanocrystalline AlFeTiCrZnCu high entropy solid solution by mechanical alloying. J Alloy Compd. 2008;460:253–257. doi: 10.1016/j.jallcom.2007.05.104
QiuXW.Microstructure and properties of AlCrFeNiCoCu high entropy alloy prepared by powder metallurgy. J Alloy Compd. 2013;555:246–249. doi: 10.1016/j.jallcom.2012.12.071
32.
PraveenS, BasuJ, KashyapS, . Exceptional resistance to grain growth in nanocrystalline CoCrFeNi high entropy alloy at high homologous temperatures. J Alloy Compd. 2016;662:361–367. doi: 10.1016/j.jallcom.2015.12.020
33.
LuY, DongY, GuoS, . A promising new class of high-temperature alloys: eutectic high-entropy alloys. Sci Rep. 2014;4:6200. doi: 10.1038/srep06200
34.
TsaiKY, TsaiMH, YehJW.Sluggish diffusion in CoCrFeMnNi high entropy alloys. Acta Mater. 2013;61:4887–4897. doi: 10.1016/j.actamat.2013.04.058
35.
NadineE, KlödenB, WeißgärberT, High-entropy alloy CoCrFeMnNi produced by powder metallurgy. Powder Metall. 2017;60:3:1–14.
36.
LiuY, WangJ, FangQ, . Preparation of superfine-grained high entropy alloy by spark plasma sintering gas atomized powder. Intermetallics. 2016;68:16–22. doi: 10.1016/j.intermet.2015.08.012
37.
PraveenS, MurtyBS, KottadaRS.Phase evolution and densification behavior of nanocrystalline multicomponent high entropy alloys during spark plasma sintering. JOM. 2013;65:1797–1804. doi: 10.1007/s11837-013-0759-0
PanigrahiBB, GodkhindiMM, DasK, . Sintering mechanisms of attrition milled titanium nano powder. J Mater Res. 2005;20(4):827–836. doi: 10.1557/JMR.2005.0116
40.
PanigrahiBB, GodkhindiMM, DasK, . Sintering kinetics of micrometric titanium powder. Mater Sci Eng A. 2005;396(1):255–262. doi: 10.1016/j.msea.2005.01.016
41.
PanigrahiBB.Evaluation of dimensional changes from as received dilatometric sintering plot. Mater Sci Technol. 2007;23(1):103–107. doi: 10.1179/174328407X158497
42.
JohnsonDL.New method of obtaining volume, grain-boundary, and surface diffusion coefficients from sintering data. J Appl Phys. 1969;40:192–200. doi: 10.1063/1.1657030
43.
ŻenkiewiczM.Methods for calculation of surface free energy of solids. J Achiev Mater Manuf Eng. 2007;24:137–145.
44.
AshbyMF.A first report on sintering diagrams. Acta Mater. 1974;22:275–289. doi: 10.1016/0001-6160(74)90167-9
45.
GermanRM.Sintering theory & practice. New York: John Wiley & sons, inc.; 1996.
NeumannG, TuijnC.Self-diffusion and impurity diffusion in pure metals: handbook of experimental data. 1st ed. Oxford, UK: Elsevier; 2009.
48.
ShewmonP.Diffusion in solids. 2nd ed. Cham, Switzerland: John Wiley and Sons Inc.; 1989.
49.
DivinskiSV, GeiseJ, RabkinE, . Grain boundary self-diffusion in α-iron of different purity: effect of dislocation enhanced diffusion. Zeitschrift für Metallkunde. 2004;95(10):945–952. doi: 10.3139/146.018036
50.
JamesDW, LeakGM.Grain boundary diffusion of iron, cobalt and nickel in alpha-iron and of iron in gamma-iron. Philosophical Magazine. 1965;12(117):491–503. doi: 10.1080/14786436508218895
